Electrolux EW30WD55GS User Manual download pdf

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS

Combination Warm & Serve Drawer/ 27" (68,6 cm) or

30" (76,2 cm) Built-in Oven Installation

P/N 318201809 (0901) Rev. D

English – pages 1-3; Español – páginas 4-6

Français – pages 7-9; Notes - pages 10-12

Warm & Serve Drawer Dimensions

Stand Alone Installation

NOTE: A 60" (152,4 cm) long cable is supplied with

the Warm & Serve Drawer.

FLOOR

Warm and Serve

Cutout

Warm and Serve

Drawer

60" (152,4 cm)

Cord

Minimum distance to ﬂoor

4½" (11,4 cm)

IMPORTANT: The Warm & Serve Drawer runs off a

single phase three-wire 120 volt, 60 hertz, AC only

electrical supply with ground.

H* = 11 7/8" (30,2 cm) Min. is a Critical

dimension and has to be respected.

Bottom of oven cutout

Caution: Two 3" (7,6 cm) wide X

3/4" (1,9 cm) thick planks have to

be install and they should be able to

support 200 pounds. (90,7 Kg)

Printed in the USA

J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven must be

lower than warmer drawer cutout.

A. HEIGHT B. WIDTH C. DEPTH

27" Models 11 ¼" (28,6 cm) 27" (68,6 cm) 23

" (59,4 cm)

30" Models 11 ¼" (28,6 cm) 30" (76,2 cm) 23

" (59,4 cm)

D. CUTOUT

HEIGHT

E. CUTOUT

WIDTH

F. CUTOUT

DEPTH

27" Models - Min. 9

" (25,1 cm) 25 ½" (64,8 cm) 23

" (60 cm)

Max. 10 ¼" (26 cm) 25 ¾" (65,4 cm) 24" (61 cm)

30" Models - Min. 9

" (25,1 cm) 28 ½" (72,4 cm) 23

" (60 cm)

Max. 10 ¼" (26 cm) 28 ¾" (73 cm) 24" (61 cm)

A. HEIGHT B. WIDTH C. DEPTH

27" Models 11 ¼" (28,6 cm) 27" (68,6 cm) 23

" (59,4 cm)

30" Models 11 ¼" (28,6 cm) 30" (76,2 cm) 23

" (59,4 cm)

D. CUTOUT

HEIGHT

E. CUTOUT

WIDTH

F. CUTOUT

DEPTH

G. HEIGHT

27" - Min. 9

" (25,1 cm) 25 ½" (64,8 cm) 23

" (60 cm) 2" (5,1 cm)

Max. 10 ¼" (26 cm) 25 ¾" (65,4 cm) 24" (61 cm)

Depends on critical

dimension H

30" - Min. 9

" (25,1 cm) 28 ½" (72,4 cm) 23

" (60 cm) 2" (5,1 cm)

Max. 10 ¼" (26 cm) 28 ¾" (73 cm) 24" (61 cm)

Depends on critical

dimension H

GENERAL INFORMATION: The Warm & Serve Drawer

can be used as a stand alone appliance or combine with a

built-in oven mounted above.

INSTALLATION AND SERVICE MUST BE PERFORMED

BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

WARNING

FOR YOUR SAFETY: Do not store or use gasoline or other

ﬂammable vapors and liquids in the vicinity of this or any other appliance.

Canada United States

IMPORTANT: The warmer drawer must be installed on

a leveled surface from left to right, rear to front and the

surface must be capable of supporting 100 lbs (45,4 Kg).

1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - BY A QUALIFIED INSTALLER

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS1Combination Warm & Serve Drawer/ 27" (68,6 cm) or 30" (76,2 cm) Built-in Oven Installa

Page 2 - INSTRUCTIONS

NOTES - NOTAS10

Page 3

NOTES - NOTAS11

Page 4 - UN INSTALADOR CALIFICADO

NOTES - NOTAS12

Page 5 - IMPORTANTES DE SEGURIDAD

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS2c/c 25 5/16" (64,3 cm)24" (61 cm) Max.23 5/8" (60 cm) Min.c/c 12 21/32" (32,2 cm

Page 6

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS3Model and Serial Number LocationThe serial plate is located as shown below.When ordering parts for o

Page 7 - L’INSTALLATION ET LE SERVICE

4INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADORDimensiones del cajón calentador Instalación de la unidad independiente Instalación de la comb

Page 8 - INSTRUCTIONS DE

5INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADORNotas importantes para el instalador1. Lea todas las instrucciones de instalación antes de inst

Page 9

6INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADORUbicación de la placa de serieEncontrará el número de serie y modelo impresos en la placa de ser

Page 10 - NOTES - NOTAS

7Dimensions du tiroir-réchaud Installation pour appareil autonome Combiné tiroir-réchaud/ four encastré de 27" (68,6 cm) ou 30" (76,2

Page 11

8Notes importantes à l’installateur1. Lisez toutes les instructions d’installation avant de procéder à l’installation de cet appareil. 2. Retirez tou

Page 12

9Emplacement des numéros de modèle et de série La plaque signalétique est située tel que montré plus bas.Lors d’une commande de pièces ou pour toute d