Electrolux EOC69400X User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
Additional Functions
You can use the Additional Functions key
to set the available Additional Func-
tions.
Additional Functions menu
Minute Minder
KEY LOCK
Duration/End Time
Meatprobe
Operation
Prior to first use
Before using the oven, first of all the lan-
guage, then the contrast of the display,
the brightness and the current time of
day must be set.
When you switch on the oven for the first
time, "SET LANGUAGE" appears in the dis-
play after a few seconds.
1. Use the Selector to select the desired
setting
2. Then press the OK key to confirm your
setting.
Make the additional basic settings required
in the same way.
Adapting oven to the kitchen
environment
For optimum results using "Auto Cooking"
the oven must be adjusted to suit the envi-
ronment. This procedure is called Calibration
and takes approximately 4 hours.
If you only want to use the oven for man-
ual cooking, it does not need to be cali-
brated.
Please take note of the following points
prior to Calibration
Calibration must take place at a
room temperature below 35°C.
For Calibration, the oven must be in-
stalled in its final location.
For Calibration, connect the oven to
the mains supply and do not discon-
nect it again.
Be sure to remove the grease filter pri-
or to Calibration.
If the installation location, electrical
connection or one of the other points
listed above is changed, the oven
must always be recalibrated so that
the "Auto Cooking" function delivers
optimum results.
You will find the calibration in the "Basic Set-
tings", "Calibration" menu.
Following calibration, the appliance is ready
to be used, as soon as it has cooled down.
Initial cleaning
The oven should be thoroughly cleaned prior
to first use. Wipe all parts and the interior with
a solution of water and washing-up liquid.
Important! Do not use any sharp or abrasive
cleaning materials. These could damage the
surface.
Switching on and off
Press the ON/OFF button.
If the oven has been switched off, the
time of day is shown. If the oven is still
hot, a bar appears in the display and
shows the residual heat remaining in the
oven.
Auto Cooking
1. Switch the oven on.
2. Press the key for the desired category.
The available dishes or subcategories
will be shown.
3. Select the desired category or the dish
directly.
4. Follow the instructions on the display.
Example: Frozen Pizza Calzone
1. Switch the oven on.
2. Press the Pizza button.
electrolux 9
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments