Electrolux EOK96030X User Manual Page 36

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 35
What to do if …
Problem Possible Cause Remedy
The oven is not heating up The oven has not been switched on Switch the oven on
The clock has not been set Set the current time on the clock
The required settings have not been
set
Check the settings
The oven's automatic switch-off
has been triggered
See Automatic switch-off
The child lock is switched on Switching off the child safety device
The fuse in the domestic wiring sys-
tem (fuse box) has been tripped
Check fuse. If the fuses trip several
times, please call a qualified electri-
cian
The oven lighting is not
operating
The oven light bulb is faulty Replace oven light bulb
"d" appears on the dis-
play and the oven does
not heat up in any mode.
Test mode is switched on Switch the appliance off, hold down
and at the same time until
the signal sounds and the "d" on
the display goes out.
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
Warning! Repairs to the appliance are
only to be carried out by qualified service
engineers. Considerable danger to the
user may result from improper repairs.
If the appliance has been wrongly oper-
ated, the visit from the customer service
technician or dealer may not take place
free of charge, even during the warranty
period.
Advice on cookers with metal fronts: Be-
cause of the cold surface at the front of
the cooker, opening the oven door dur-
ing (or just after) baking or roasting may
cause the glass to steam up.
Installation Instructions
Caution! The new appliance may only
be installed and connected by a
registered installation engineer. Please
comply with this instruction. If you do
not, any damage resulting is not covered
by the warranty.
To prevent future hazards, damaged mains
cables must only be replaced by a qualified
electrician.
Safety information for the installer
The set-up of the electrical installation is
arranged so that the appliance can be iso-
lated from the mains with a minimum 3mm
all-pole contact separation.
Suitable separation devices include e. g.
cut-outs, fuses (screw fuses are to be tak-
en out of the holder), RCD's and contac-
tors.
The site must provide a connection to the
electrical supply by means of a socket that
is accessible and outside the coordination
space.
Anti-shock protection must be provided by
the installation.
The built-in unit must meet the stability re-
quirements of DIN 68930.
36 electrolux
Page view 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comments to this Manuals

No comments