Electrolux EWX147410W User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
10.8 Cancelling a running
programme
1. Turn the programme knob to On/Off
position to cancel the programme.
The appliance is deactivated.
2. Now, you can set a new washing
programme and the available options.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment; if
not, fill the detergent again.
10.9 Opening the door
While a programme is running or during
the Delay Start, the appliance door is
locked. The indicator is on.
CAUTION!
If the temperature and level of
the water in the drum are too
high and the drum still
rotates, you cannot open the
door.
To open the door during the first minutes
of the cycle or when the Delay Start
operates:
1. Press the Start/Pause button to pause
the appliance.
2. Wait until the indicator
goes off.
3. You can open the door.
4. Close the door and press the Start/
Pause button again.
The programme (or the Delay Start)
continues.
10.10 At the end of the
programme
The appliance stops automatically.
Some acoustic signals sound (if they
are activated).
In the display the value come
on. The Start/Pause indicator goes off.
When the door lock indicator
goes
off, you can open the door.
Remove the laundry from the
appliance. Make sure that the drum is
empty. Close the water tap.
Turn the programme knob to On/Off
position to deactivate the appliance.
Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
The drum turns regularly to prevent the
creases in the laundry.
The door lock indicator
is on. The
door stays locked.
You must drain the water to open the
door.
To drain the water:
1. Turn the programme knob to On/Off
position an then select a spinning or
draining programme.
2. Press the Start/Pause button. If
necessary, decrease the spin speed.
The appliance spins and drains or only
drains.
3. When the programme is completed
and the indicator
goes off, you can
open the door.
4. Turn the programme knob to On/Off
position to deactivate the appliance.
10.11 Stand-by
Once the programme has finished, after a
few minutes the energy saving system will
be enabled.
The brightness of the display is reduced.
By pressing any button the appliance will
come out of the energy saving status.
11. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
www.electrolux.com18
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments