Electrolux EWX147410W User Manual download pdf (Page 22)

Never remove the pump cover during a

wash cycle, always wait until the appliance

has finished the cycle, and is empty. When

refitting the pump cover, ensure it is se-

curely retightened so as to stop leaks and

young children being able to remove it.

CLEANING THE WATER INLET

FILTERS

If you notice that the machine is taking lon-

ger to fill, check that the filter in the water

inlet hose is not blocked.

1. Turn off the water tap.

2. Unscrew the water inlet hose.

3. Clean the filter in the hose using a hard

bristle brush.

4. Screw the hose back onto the tap.

5. Unscrew the hose from the machine.

Keep a rug nearby because some wa-

ter may flow.

6. Clean the filter in the valve with a stiff

brush or with the piece of cloth.

7. Screw the hose back to the machine

and make sure the connection is tight.

8. Turn on the water tap.

FROST PRECAUTIONS

If the machine is installed in a place where

the temperature could drop below 0°C,

proceed as follows:

1. Turn off the water tap.

2. Unscrew the inlet hose.

3. Place the end of the emergency empty-

ing hose and that of the inlet hose in a

bowl placed on the floor and let water

drain out.

4. Screw the water inlet hose back on and

reposition the emergency emptying

hose after having put the cap on again.

5. When you intend to start the machine

up again, make sure that the room

temperature is above 0°C.

EMERGENCY EMPTYING OUT

If the water is not discharged, proceed as

follows to empty out the machine:

1. pull out the plug from the power sock-

et;

2. close the water tap;

3. if necessary, wait until the water has

cooled down;

4. place a bowl on the floor and place the

end of the emergency emptying hose

into the bowl. Remove its cap. The wa-

ter should drain by gravity into the

bowl. When the bowl is full, put the cap

back on the hose. Empty the bowl. Re-

peat the procedure until water stops

flowing out;

5. clean the pump if necessary as previ-

ously described;

6. replace the emergency emptying hose

in its seat after having plugged it;

7. screw the pump again.

WHAT TO DO IF…

Certain problems are due to lack of simple

maintenance or oversights, which can be

solved easily without calling out an engi-

neer. Before contacting your local Service

Centre, please carry out the checks listed

below.

During machine operation it is possible that

the red pilot light of button 8 blinks, one of

the following alarm codes appears on the

display and some acoustic signals sound

every 20 seconds to indicate that the ma-

chine is not working:

•

: problem with the water supply.

•

: problem with the water draining.

•

: door open.

22 electrolux

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Comments to this Manuals

No comments