Electrolux EWX147410W User Manual download pdf (Page 26)

3. 4.

45°

20°

14.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Place the end of the emergency

emptying hose and that of the inlet

hose in a bowl placed on the floor

and let water flow out of the hoses.

4. Set the Drain programme and let it

operate until the end of the cycle.

5. Turn the programme knob to On/Off

to disconnect the appliance from the

power supply.

6. Screw the water inlet hose back on

and re-fit the emergency emptying

hose after having put the cap on

again.

WARNING!

Make sure that the

temperature is more than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

14.9 Emergency emptying out

If the appliance does not drain the water,

proceed as follows:

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. If necessary, wait until the water has

cooled down.

4. Place a bowl on the floor and put the

end of the emergency emptying hose

into the bowl. Remove its cap.

The water should drain by gravity into the

bowl.

5. When the bowl is full, put the cap

back on the emergency hose.

6. Empty the bowl. Repeat the

procedure until water stops flowing

out.

7. Clean the pump if necessary as

previously described.

8. Replace the emergency emptying

hose in its seat after having plugged

it.

9. Screw the water inlet hose back on.

15. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

15.1 Introduction

The appliance does not start or it stops

during operation.

www.electrolux.com26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comments to this Manuals

No comments