Electrolux EWX147410W User Manual download pdf (Page 29)

Problem Possible cause/solution

The washing results

are not satisfactory.

Increase the detergent quantity or use a different detergent.

Use special products to remove the stubborn stains before

you wash the laundry.

Make sure that you set the correct temperature.

Decrease the laundry load.

The machine does not

dry or does not dry

properly:

Make sure that you have set a suitable drying programme

for your laundry.

Make sure that you set the correct the drying time or dry‐

ness degree.

Make sure that the water tap is not turned on.

Make sure the drain filter is not clogged.

Make sure you have not overloaded the appliance.

The laundry is full of

different coloured fluff:

The fabrics washed in the previous cycle released fluff of a

different colour.

Clean the clothes with a fluff remover

The drying phase helps to eliminate some fluff.

In case of an excessive

amount of fluff in the

drum, refer to section

«FLUFF IN THE FAB‐

RICS».

• Thoroughly clean the empty drum, the gasket and the

door with a wet rag.

• Perform a rinse cycle.

• Put a wool or piled fabric rag inside the drum.

• Perform a drying cycle of 10 minutes.

• Remove the old wool cloth.

Now you can wash other garments.

After the check, activate the appliance.

The programme continues from the point

of interruption.

If the problem occurs again, contact the

Authorised Service Centre.

If the display shows other alarm codes.

Deactivate and activate the appliance. If

the problem continues, contact the

Service.

16. INSTALLATION

16.1 Unpacking

WARNING!

Remove all the packaging and the transit bolts before installing the

appliance.

ENGLISH 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Electrolux EWX147410W User Manual Page 29

Comments to this Manuals

Related products and manuals for Washing machines Electrolux EWX147410W