InstantaneousWater HeaterInstructions for installation and useIH 18 electronic basicIH 21 electronic basicIH 24 electronic basic
10Water connectionThe water inlet temperature on the cold water connection should bemax. 25°C.If plastic pipe systems are used as installation materia
11Installation versionsFor fittings directly on the appliance, the bushing openings pre-embossed inthe appliance hood must be cut out for the extensio
12− Shut off cold water on shutoff unit (1)− Loosen cap nut (2) using a spanner− Take out and clean strainer (3)− Re-assemble in reverse sequence− Ope
13Electrical connectionThe electrical connection should only ever be made after the water isconnected! The appliance is only suitable for a fixed conn
14Mains connection underneath (alternative)For this connectionversion, transpose themains connection terminal(1) from top to bottom.Note the terminald
15Temperature selector range limitationThe maximum temperature able to beset can be limited to 40°C or 45°C.Important! Before dismantling, setthe knob
16Using the appliance for the first time and checkingThe unit must be installed and started up by an approved firm of installerswhich accepts liabilit
17Check the voltageClean strainer insert (seepage 12)Dismantle and clean thebubblers and showersheadsInspection and repair onlyby the trained engineer
18Fault indications- L1 or L3 phase missing- L2 phase missing*) The individual fault are indicated every 5 sec. The indication mode startsafresh every
19Important for the expertThe electronic controls the safety-function of the appliance. When a fault isnoticed, the fault indicator (LED) blinks and t
2Contents PageImportant instructions for the user 3General 3Operating the appliance 3Temperature preselection 3Hot water flowrate 4Care and maintenanc
Customer serviceIf your appliance has a fault, please contact your customer service centre foradvice.Electric appliances should only ever be repaired
3When the appliance is operated with athermostatic mixer tap, the temperaturesetting on the instantaneous waterheater must be around 8°C higher than
4Hot water flowrateUp to the appliance’s max. power limit, the instantaneous water heatersupplies the set hot water temperature regardless of the wate
5Important instructions for the installerGeneralThe instantaneous water heater is manufactured and tested in conformity withthe valid IEC specificatio
6Technical data*) In addition to the flow pressures of the instantaneous water heater itself, considerationmust be given to the pressure losses in the
7Appliance functionThe fully electronically controlled ELECTROLUX IH instant water heater is apressurised appliance for the supply of one or more tapp
8Installing the applianceThe appliance should only ever be installed or stored in frost-freepremises.Dimensioned diagram1 = Quick fastener for applian
9Appliance installationCarefully unpack and take out the enclosed pack.Prepare the appliance for assembly.Hood dismountingPress in the engagement lug
Comments to this Manuals