Electrolux DBGL5430CN User Manual download pdf (Page 4)

4

www.electrolux.com

1. RECOMMENDATIONS

AND SUGGESTIONS

• The Instructions for Use apply

to several versions of this ap-

pliance. Accordingly, you may

nd descriptions of individual

features that do not apply to

your specic appliance.

• The manufacturer will not be

held liable for any damages

resulting from incorrect or

improper installation.

• The minimum safety distance

between the cooker top and

the extractor hood is 650 mm

(some models can be installed

at a lower height, please refer

to the paragraphs on working

dimensions and installation).

• Check that the mains voltage

corresponds to that indicated

on the rating plate xed to the

inside of the hood.

• For Class I appliances, check

that the domestic power supply

guarantees adequate earth-

ing. Connect the extractor to

the exhaust ue through a pipe

of minimum diameter 120 mm.

The route of the ue must be

as short as possible.

• Do not connect the extractor

hood to exhaust ducts carry-

ing combustion fumes (boilers,

replaces, etc.).

• If the extractor is used in con-

junction with non-electrical ap-

pliances (e.g. gas burning ap-

pliances), a sufcient degree of

aeration must be guaranteed in

the room in order to prevent the

backow of exhaust gas. The

kitchen must have an open-

ing communicating directly

with the open air in order to

guarantee the entry of clean

air. When the cooker hood is

used in conjunction with ap-

pliances supplied with energy

other than electric, the negative

pressure in the room must not

exceed 0,04 mbar to prevent

fumes being drawn back into

the room by the cooker hood.

• In the event of damage to

the power cable, it must be

replaced by the manufacturer

or by the technical service

department, in order to prevent

any risks.

• If the instructions for installa-

tion for the gas hob specify

a greater distance specied

above, this has to be taken into

account. Regulations concern-

ing the discharge of air have

to be fullled.

• Use only screws and small

parts in support of the hood.

Warning: Failure to install

the screws or xing device in

accordance with these instruc-

tions may result in electrical

hazards.

• Connect the hood to the mains

through a two-pole switch hav-

ing a contact gap of at least

3 mm.

2. USE

• The extractor hood has been

designed exclusively for do-

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments