Electrolux K 818 40 i User Manual download pdf (Page 10)

Important! Do not touch frozen food with wet hands. Your hands could

stick to the food.

1. Place the packed food in the drawers. Place food to be frozen in the upper

drawer. Unfrozen food must not touch items already frozen, otherwise the

frozen food could begin to defrost.

2. Place frozen foods in the drawers sorted by type, as far as possible. Index

tabs are supplied for placing on drawers. To mark the contents of the indi-

vidual drawers, press the index tab over the corresponding symbol (see "Fro-

zen Food Symbols/Freezer Calendar" section). This will give you a better

overview of the contents, avoid extended door opening and therefore save

electricity.

Preparation of Ice Cubes

1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-

partment and leave to freeze.

2. To loosen the frozen cubes, either twist the ice cube tray or hold it under

running water for a few seconds.

Important! Never try to free an ice tray that is frozen to the freezer com-

partment using pointed or sharp edged objects. Use the ice scraper supplied.

Defrosting

Refrigerator

Frost is automatically eliminated from the evaporator of the refrigerator

compartment every time the motor compressor stops, during normal use.

The defrost water drains out through a trough into a special container at

the back of the appliance, located over the motor compressor, where it

evaporates.

Freezer

The freezer compartment, however, will become progressively covered with

frost. This should be removed with the special plastic scraper provided,

whenever the thickness of the frost exceeds 4 mm. During this operation it

is not necessary to switch off the power supply or to remove the foodstuffs.

Installation Location

This appliance should only be installed at a location where the ambient

temperature corresponds to the climate classification indicated on the rat-

ing plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each

climate classification.

Climate classification for an ambient temperature of

SN +10 to +32 °C

N +16 to +32 °C

Your appliance needs air

For safety reasons, minimum ventila-

tion must be as shown Fig.

Attention: keep ventilation openings

clear of obstruction;

50 mm

min.

200 cm

min.

D567

Reversing the door

The side the door opens can be changed from the right side (factory adjust-

ment) to the left side, if the installation site requires.

Warning! When changing the side the door opens, the appliance must not

be connected to the mains. Remove plug from the mains beforehand.

The appliance should be located in a dry atmosphere, out of direct sunlight

and away from continuous heat and extreme temperature, e.g. not next to

a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-

peratures are exceeded i.e. warmer or colder, then the appliance may not

operate correctly.

For building-in and door reversal instructions please refer to the relevant

instructions on the following pages.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Electrolux K 818 40 i User Manual Page 10

Comments to this Manuals

Related products and manuals for Combi-fridges Electrolux K 818 40 i