Electrolux EXP09HN1WI User Manual download pdf (Page 16)

16 www.electrolux.com

t Wash the lter using liquid dishwashing

detergent and warm water. Rinse lter

thoroughly. Gently shake excess water

from the lter. Be sure lter is thoroughly

dry before replacing.

t Or, instead of washing you may vacuum

the lter clean.

7.2 Cabinet Cleaning

t Be sure to unplug the air conditioner

to prevent shock or re hazard. The

cabinet and front may be dusted with

an oil-free cloth or washed with a cloth

dampened in a solution of warm water

and mild liquid dishwashing detergent.

Rinse thoroughly and wipe dry.

t Never use harsh cleaners, wax or polish

on the cabinet front.

t Be sure to wring excess water from

the cloth before wiping around the

controls. Excess water in or around the

controls may cause damage to the air

conditioner.

7.3 Winter Storage

t If you plan to store the appliance during

the winter, cover it with plastic or return

it to its carton.

t For the model which with accessory

of storage cover, use it directly for the

appliance storage.

8. BEFORE YOU CALL

Air conditioner will not operate.

t Wall plug disconnected. Push plug

rmly into wall outlet.

t Plug Current Device Tripped. Press the

RESET button.

t House fuse blown or circuit breaker

tripped. Replace fuse with time delay

type or reset circuit breaker.

t Control is OFF. Turn Control ON and set

to desired setting.

t P1 appears in the display window.

Drain water as described in Drainage

Section.

t Shut off in Heat mode. When the air

outlet exceeds 70 °C (158 °F), the

automatic heat protection engages.

Romove any blockages and let

appliance cool down.

t Room Temperature lower than the set

temperature (Cool Mode). Reset the

temperature.

t Room Temperature higher than the set

temperature (Heat Mode). Reset the

temperature.

Air from unit does not feel cold

enough.

t Room temperature below 16 °C (60°F).

Cooling may not occur until room

temperature rises above 16 °C (60 °F).

t Reset to a lower temperature.

t Compressor shut-off by changing

modes. Wait approximately 3 minutes

and listen for compressor to restart

when set in the COOL mode.

Air conditioner cooling, but room is

too warm - NO ice forming on cooling

coil behind decorative front.

t Outdoor temperature below 16 °C

(60°F). To defrost the coil, set FAN

ONLY mode.

t Air lter may be dirty. Clean lter. Refer

to Care and Cleaning section. To

defrost, set to FAN ONLY mode.

t Temperature is set too low for night-

time cooling. To defrost the coil,

set to FAN ONLY mode. Then, set

temperature to a higher setting.

t Exhaust duct not connected or

blocked. See EXHAUSTING HOT AIR

Section.

Air conditioner cooling, but room is

too warm - ice forming on cooling coil

behind decorative front

t Dirty air lter - air restricted. Clean

air lter. Refer to Care and Cleaning

section.

t Temperature is set too high. Set

temperature to a lower setting.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 99 100

Comments to this Manuals

No comments