Electrolux CXD15DN3W User Manual download pdf (Page 5)

www.electroluxaircomfort.com 5

OPERATING INSTRUCTIONS

Allow the unit to reach room temperature before

operating. To begin operating the dehumidiﬁ er,

follow these steps:

Unit must be upright for one hour prior to

operating.

1. Plug the power cord into a properly

grounded 220 V AC outlet. If the BUCKET

FULL light is on, remove the bucket and re-

install to reset the ﬂ oat switch.

2. To turn the unit on, press the ON/ OFF

button . The unit will run in the factory

setting of CONTINUOUS and high fan

speed. In the CONTINUOUS mode, the

unit will only display CO and not the room

humidity. It is recommended you leave the

unit running in the CONTINUOUS setting for

the ﬁ rst three or four days until the sweating

and dampness odours have stopped.

3. After a few days when the Relative Humidity

has declined, press the HUMIDITY or

buttons to choose a value between 35% to

85%, so the room is kept at a comfortable

humidity. Pressing the or buttons

will change the humidity selection in 5%

increments. After you have set the desired

humidity, the readout will display the actual

room humidity. If at any time you want to

return to the CONTINUOUS Mode, pressing

the HUMIDITY button will lower the

Relative Humidity through the 5% increments

until the display reads CO.

4. You can also use the FAN SPEED button

to change the fan speed to HIGH or LOW.

The indicator light will show the setting you

have selected. A higher fan speed will result

in quicker moisture removal.

5. The CLEAN FILTER light will illuminate after

250 hours of operation. At this time refer

to the care and cleaning section to remove

and clean the ﬁ lter. Once the ﬁ lter has been

cleaned and replaced, simply press the

FILTER button to extinguish the light.

6. The TIMER function enables you to either

Delay Start or Delay Stop the unit in the

choice from 0.5 hour to 24 hours. If the unit

is running, then selecting Timer will turn the

unit off in the hours that will be set (Delay

Stop). If the unit is off, then selecting Timer

will turn the unit on in the hours that will be

set (Delay Start).

TIMER setting:

First press TIMER button , then adjust

timer setting, by tapping or holding the or

button to change the delay timer at 0.5 hour

increments, up to 10 hours, then by 1 hour

increments up to 24 hours. The control will

count down the time remaining (8, 7.5, 7, etc.)

until the unit either starts or stops.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments