Electrolux ESF 46010 User Manual download pdf (Page 38)

38 electrolux installation

Our appliances are supplied with a

security device to protect against the

return of dirty water back into the

machine.

If the spigot of your sink has a ‘no

return valve’ incorporated this can

prevent the correct draining of your

dishwasher. We therefore advise you

to remove it.

When connecting the drain hose to an

under sink trap spigot, the entire

plastic membrane (A) must be

removed. Failure to remove all the

membrane will result in food particles

building up over time eventually

blocking the dishwasher drain hose

spigot

Water outlet hose connection

The end of the drain hose can be

connected in the following ways:

1. To the sink outlet spigot, securing

it to the underside of the work

surface. This will prevent waste

water from the sink running into

the machine.

2. To a stand pipe provided with vent-

hole, minimum internal diameter 4

cm.

The waste connection must be at a

height of between 30 cm (minimum)

and 100 cm (maximum) from the

bottom of the dishwasher.

The drain hose can face either to the

right or left of the dishwasher

Ensure the hose is not bent or

squashed as this could prevent or

slow down the discharge of water.

The sink plug must not be in place

when the machine is draining as this

could cause the water to syphon back

into the machine.

If you use a drain hose extension it

must be no longer than 2 metres and

its internal diameter must be no

smaller than the diameter of the hose

provided.

Likewise the internal diameter of the

couplings used for connections to the

waste outlet must be no smaller than

the diameter of the hose provided.

117988 42/0en 9-02-2007 9:42 Pagina 38

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Comments to this Manuals

No comments