Electrolux ESL46010 User Manual download pdf (Page 5)

• To set the water softener. Refer to the

chapter 'Setting the water softener'.

• To deactivate/activate the audible signals.

Refer to the section 'Audible signals'.

• To deactivate/activate the rinse aid dis-

penser, when multitab function is active.

Refer to the chapter 'Multitab function'.

Setting mode

The appliance must be in setting mode for

these operations:

• To set a washing programme.

• To set the water softener level.

• To deactivate/activate the audible signals.

• To deactivate/activate the rinse aid.

Press the on/off button. The appliance is in

setting mode when:

– All the programme indicator lights come

on.

Press the on/off button. The appliance is not

in setting mode when:

– Only one programme indicator light comes

on.

– A washing programme is set. It is neces-

sary to cancel the programme to go back

to setting mode. Refer to 'Setting and

starting a washing programme'.

Audible signals

You can hear an audible signal:

• At the end of the washing programme.

• During the setting of the level of the water

softener.

• When the appliance has a malfunction.

The activation of the audible signals is set at

the factory.

Do these steps to deactivate the audible sig-

nals:

1. Switch on the appliance.

2. Make sure that the appliance is in setting

mode.

3. Press and hold function buttons B and C

until the indicator lights of function but-

tons A, B and C start to flash.

4. Release function buttons A and B.

5. Press the function button C.

– Indicator lights for function buttons A

and B go off.

– Indicator light for function button C

flashes.

– The digital display shows the setting.

Audible signals deactiva-

ted

Audible signals activated

The audible signals are activated.

6. Press the function button C again.

– The digital display shows the new set-

ting.

The audible signals are deactivated.

7. Switch off the appliance to save the op-

eration.

Do these steps to activate the audible sig-

nals:

1. Do the above procedure until the digital

display shows necessary setting.

Use of the appliance

Refer to the following instructions for each

step of procedure:

1. Make a check if the water softener level

is correct for the water hardness in your

area. If necessary set the water softener.

2. Fill the salt container with dishwasher salt.

3. Fill the rinse aid dispenser with rinse aid.

4. Load cutlery and dishes into the dish-

washer.

5. Set the correct washing programme for

the type of load and soil.

6. Fill the detergent dispenser with the cor-

rect quantity of detergent.

7. Start the washing programme.

If you use combi detergent tablets ('3 in

1', '4 in 1', '5 in 1', etc.), refer to the

chapter 'Multitab function'.

Setting the water softener

The water softener removes minerals and

salts from the water supply. Minerals and

salts can have bad effect on the operation of

the appliance.

Water hardness is measured in equivalent

scales:

• German degrees (dH°).

• French degrees (°TH).

electrolux 5

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments