Electrolux GA55IEEV User Manual download pdf (Page 63)

Problem Possible cause Possible solution

The water tap is clogged or

there is limescale on it.

Clean the water tap.

The filter in the water inlet

hose is clogged.

Clean the filter.

The water inlet hose has a

kink or a bend.

Make sure that the position

of the hose is correct.

The anti-flood device is on.

There are water leakages in

the appliance.

Close the water tap and

contact the Service.

The appliance does

not drain the water.

The sink spigot is clogged. Clean the sink spigot.

The water drain hose has a

kink or a bend.

Make sure that the position

of the hose is correct.

After the checks are completed, activate

the appliance. The programme continues

from the point of interruption.

If the problem occurs again, contact the

Service.

If the display shows other alarm codes,

contact the Service.

10.1 If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a

lower position.

• The quantity of detergent is too much.

Stains and dry water drops on

glasses and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector

to a higher position.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature drying

phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

• The quality of the combi detergent tab-

lets can be the cause. Try a different

brand or activate the rinse aid dispens-

er and use rinse aid together with the

combi detergent tablets.

Refer to ‘HINTS AND TIPS’ for

other possible causes.

Activating the rinse aid

dispenser with the multitab

option activated

1.

Press the on/off button to activate the

appliance. Make sure that the appli-

ance is in setting mode. Refer to ‘SET-

TING AND STARTING A PRO-

GRAMME’.

2.

Press and hold buttons (8) and (9) at

the same time until the programme in-

dicators above buttons (8), (9) and (10)

flash.

3. Press button (9) .

• The programme indicators above

buttons (8) and (10) go off.

• The programme indicator above

button (9) continues to flash.

• The display shows the setting of the

rinse aid dispenser.

Off

On

4. Press button (9) to change the setting.

5. Deactivate the appliance to confirm.

6. Adjust the released quantity of rinse

aid.

7. Fill the rinse aid dispenser.

ENGLISH 63

1 2 ... 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments