Electrolux SANTO Series User Manual download pdf (Page 16)

Prior to Initial Start-Up

Before connecting the appliance to the mains and putting it into ope-

ration for the first time, leave the appliance to stand for 30 minutes if

it was transported upright. After transport on its side, the appliance

must be left to stand for 2 hours before putting it into operation. This is

necessary to allow the oil to flow back into the compressor. Otherwise

the compressor may be damaged.

0 1. Please clean the appliance interior and all accessories prior to initial

start-up (see section: "Maintenance and Cleaning").

Starting Up and Regulating the Temperature

Fridge and freezer sections can each be regulated independently of the

other. The control panel is situated behind the fridge door at the top of

the fridge section.

0 1. Insert plug into mains socket. Within 20 seconds the electronics carry

out a system test and switch the appliance on. The ON/OFF button

lights up in green, the interior lighting comes on and the appliance

starts working. If the temperature warning signal sounds, this can be

switched off by pressing the ALARM OFF button.

Starting up when the appliance is switched off:

Press and hold down the ON/OFF button for three seconds. The ON/OFF

button lights up in green, the interior lighting comes on and the

appliance starts working. If the temperature warning signal sounds, it

can be switched off by pressing the ALARM OFF button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Electrolux SANTO Series User Manual Page 16