Electrolux ER8366B User Manual download pdf (Page 4)

Changing the opening direction

of doors and Panelling

Fig. 6

Fig. 7

If you wish to change the opening side of the doors pro-

ceed as follows:

1... Remove the handles of the doors.

2... Take off the plinth pressed onto cabinet.

3... Remove the lower hinge taking care for the lower

door not to fall off.

4... Lift the lower door off the central hinge.

5... Remove the central hinge taking care for the upper

door not to fall off and not to lose the plastic was-

her.

6... Take the upper door off the upper hinge. Be carefull

not to lose the plastic washer.

7... Unscrew the plastic plugs located on the opposite

side of the central hinge and introduce them in the

holes occupied before by the hinge.

8... Unscrew the axle of the upper hing and screw it into

the hinge on the opposite side. Make sure to fit in the

metal washer for blocking.

9... Place upper door.

For the remaining parts proceed the other way round.

Once finished make sure that all joints close per-

fectly well all around the door and chek that the inter-

nal light turns of when the fridge door closes.

How to decor the doors:

If your appliance is provided with metal strips for

panelling and you wish to do so proceed as

follows:

1... Remove one of the side strips.

2... Loosen the screws of the remaining strips.

3... Start putting on the panel where you took off

the strip pushing it right up to the end.

4... Replace the strip on this side.

5... Tighten all screws

NOTE:

The panel dimensions must be 2 mm. shor-

ter than the doors. Maximun thickness of the panel

is 4 mm.

1 2 3 4 5 6 7 8 9 ... 14 15

No comments

Electrolux ER8366B User Manual Page 4