Electrolux EGG6343NOX User Manual

EGG6343... ...EN HOB USER MANUAL

Problem Possible cause RemedyThe gas ring burns un-evenly• Burner crown isblocked with food resi-dues• Make sure that the in-jector is not blockedand

WARNING!The following instructions aboutinstallation, maintenance and ven-tilation must be carried out byqualified personnel in compliancewith the reg

• If you change from natural gas G20 20mbar to liquid gas, fully tighten the by-pass screw in.• If you change from liquid gas to naturalgas G20 20 mba

If you install the hob under ahood, please see the installationinstructions of the hood for theminimum distance between theappliances.8.7 Possibilitie

Gas supply: G20 (2H) 20 mbarAppliance class: 3By-pass diametersBurner Ø By-pass in1/100 mmBurner Ø By-pass in1/100 mmAuxiliary 28 Triple Crown 56Semi-

ENGLISH 15

www.electrolux.com/shop892953194-A-292012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY INSTRU

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible if

• Never try to extinguish a fire with water, but switch offthe appliance and then cover flame e.g. with a lid or afire blanket.• Do not store items on

nect the appliance from the mains at allpoles. The isolation device must have acontact opening width of minimum 3mm.• Use only correct isolation devic

• Clean regularly the appliance to preventthe deterioration of the surface material.• Do not use water spray and steam toclean the appliance.• Do not

4.1 Ignition of the burnerWARNING!Be very careful when you useopen fire in kitchen environment.Manufacturer decline any respon-sibility in case misuse

5. HELPFUL HINTS AND TIPSWARNING!Refer to safety chapters.5.1 Energy savings• If possible, always put the lids on thepans.• When the liquid starts to

• Make sure you position the pan sup-ports correctly after cleaning.• To make the burners work correctly,make sure that the arms of the pansupports ar