Electrolux AW 465 Specifications download pdf (Page 10)

PREPARATION FOR USE

For models working with batteries follow the

instructions below, whereas in the case of mains

operated models the transformer (or mains unit)

has already been placed inside the machine and

needs no further installation.

The batteries are supplied without liquid, therefore

they must be ﬁlled up with the appropriate acid

solution (concentration greater than 30%) before

they can be used.

Take special care when handling the acid

solution as it is corrosive. If it should

come into contact with skin or eyes,

wash abundantly with water and consult

a doctor.

The AW445, AW445 T and AW455 T

models use two 12 Volt batteries connected

in series.

The AW465 and AW475 models use four 6

Volt batteries connected in series. Please study

the applicable illustration then ﬁt the batteries

and connect the supplied links as indicated.

When the battery set has been properly charged

plug the battery socket into the machine as

shown. Lower the tank unit to safely cover

exposed working parts.

Remove the cap from the hose unscrewing the

knob and empty the tank.

There is a water level sensor also in the tank for

the clean water (A).

When the tank is going to be empty the red light

B will turn-on; 80 seconds later the automatic

switch “off” of the water ﬂow (electrovalves and

water pump) will occur and a beep will be

heared.

The display A normally shows the voltage of the

battery (or the output voltage of the transformer

unit for the machines with mains cable).

By pushing button B one time the working hours

of the machine will be shown (hour meter); by

pushing the button B two times the working

minutes will be shown. Push the third time or wait

10 seconds to restore the battery voltage.

SCRUBBING AND DRYING OPERATION

OFF

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Electrolux AW 465 Specifications Page 10

Comments to this Manuals