Electrolux EWW12853 User Manual download pdf (Page 14)

14 www.electrolux.com

●

●

●

●

●

●

●

●

If you wish to add laundry in the machine

during the delay time, press “Start/Pause

” touchpad to put the machine in pause

mode. Add laundry, close the door and

press “Start/Pause ” touchpad again.

You can cancel the delay time at any

moment, by pressing “Delay Start”

touchpad repeatedly till the display shows

delay time “ ”, then press the

“Start/Pause ” touchpad.

Delay Start

This option makes it possible to delay the

start of the program by 30 min, 60 min or

90 min and then by every hour from 2 to

19 hours.

The delay you have selected is indicated

on the display. The end time will increase

in order to show you the selected delay.

You must select this option after you have

set the program and before you press the

“Start/Pause ” button.

The drying time can vary according to :

the final spin speed;

dryness level (Extra Dry or Cupboard

Dry or Iron Dry);

the type of laundry;

the size of load.

Duration of the drying cycle

To prevent the formation of

creases or shrinking of fabrics,

avoid excessive drying.

WARNING!

Should the laundry still be too wet

at the end of the program, set

another short drying cycle.

The final part of a washer- dryer

cycle occurs without heat (cool

down cycle). This ensures the

laundry will be left at a low

temperature.

Additional drying

Prewash Touchpad

Select this option if you wish your laundry

to be pre-washed before the main wash.

Use this option for heavy soil. The

indicator of this option will be on.

When you set this function, put the

detergent into the “ ” compartment.

This function increases the program

duration.

Rinse Plus Option

This option is recommended for people

who are allergic to detergents, and in

areas where the water is very soft. Use

this option to add two rinse phases to a

program.

To activate this option, press “Dry Time

” and “Delay Start ” touchpads at

the same time until the display shows

the symbol “ ”.

To deactivate this option, press “Dry

Time ” and “Delay Start ”

touchpads at the same time until the

symbol “ ” goes off.

After drying fluffy fabrics, such as new

towels, it is advisable to perform a

“Maintenance Wash” (see page 27) to

ensure that any residue that may remain

in the tub is completely removed and

does not stick to garments dried

afterwards. After each drying cycle, clean

the drain pump filter. Please refer to care

and cleaning in section 10 “CARE AND

CLEANING”.

Fibre residue

Time Manager

This option allows you to adjust the wash

time. Press this touchpad repeatedly to

decrease or increase the wash time

according to the soil level of your wash.

Use the table below as a guide.

This option remains enabled even after

the appliance is switched off.

Soil Level

Light Medium Normal Heavy

Wash Level

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments