Electrolux EOB6850AOX User Manual download pdf (Page 34)

1

2

10.

Carefully lift (step 1) and remove (step

2) the glass panels one by one. Start

from the top panel.

11.

Clean the glass panels with water

and soap. Dry the glass panels care-

fully.

Installing the door and the glass panel

When the cleaning is completed, install

the glass panels and the oven door. Do

the above steps in the opposite se-

quence.

Make sure that you put the glass panels

back in the correct sequence. The second

panel has a decorative frame. The screen-

printing zone must face the inner side of

the door. Make sure that after the installa-

tion the surface of the glass panel frame

on the screen-printing zones is not rough

when you touch it.

Make sure that you install the middle pan-

el of glass in the seats correctly (refer to

the illustration).

11.5 Cleaning the water tank

WARNING!

Do not put water into the water

tank during the cleaning proce-

dure.

During the cleaning procedure,

some water can drip from the

steam inlet onto the cavity of the

oven. Put a dripping pan on the

shelf level directly below the

steam inlet to prevent water from

falling onto the bottom of the oven

cavity.

After some time, you can have lime de-

posits in your oven. To prevent this, clean

the parts of the oven that generate the

steam. Empty the tank after each steam

cooking.

1.

Fill in the water tank with 900 ml of

water and 50 ml of citric acid (five

teaspoons). Deactivate the oven and

wait for approximately 60 minutes.

2.

Activate the oven and set the True

Fan + Steam function. Set the tem-

perature 230 °C. Deactivate it after 25

minutes and let it cool down for 15

minutes.

3.

Activate the oven and set the True

Fan + Steam function. Set the tem-

perature between 130 and 230 °C.

Deactivate it after 10 minutes. Let it

cool down and continue with the re-

moval of the tank contents (refer to

"Emptying the water tank").

4.

Rinse the water tank and clean the

remaining lime residue in the oven

with a cloth.

5.

Clean the drain pipe by hand in warm

water with soap. To prevent damage,

do not use acids, sprays or similar

cleaning agents.

Types of water

• Soft water with low lime content -

the manufacturer recommends this be-

cause it decreases the quantity of

cleaning procedures.

34

www.electrolux.com

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 79 80

Comments to this Manuals

No comments