Electrolux EOBP9901VX User Manual download pdf (Page 55)

This is not the end of

the cleaning

procedure. Follow the

message in the

display to complete

the cleaning.

c) Wipe the cavity of the oven with a

non-abrasive surface care

sponge. You can use warm water

or oven detergents.

d) The final part of the procedure

starts. The duration of this stage is

around 25 minutes.

3.

Wipe the cavity of the oven with a

non-abrasive sponge. You can use

warm water.

4. Remove the remaining water from the

water drawer.

After cleaning keep the oven door open

for approximately 1 hour. Wait until the

oven is dry. To speed up the drying you

can heat up the oven with hot air at

temperature 150 °C for approximately 15

minutes. You can get maximum effects of

the cleaning function if you manually clean

the oven immediately after the function

ends.

12.5 Cleaning Reminder

When reminder is displayed cleaning is

necessary. Perform the function Steam

Cleaning Plus.

You can enable / disable the function:

Cleaning Reminder in the menu: Basic

Settings.

12.6 Cleaning the water drawer

Remove the water drawer from the

appliance.

1. Remove the lid of the water drawer.

Lift the cover in correspondence with

the protrusion in the rear.

XAM

2. Remove the wave-breaker. Pull it

away from the drawer body until it

snaps out.

3. Wash the water drawer parts with

your hands. Use tap water and soap.

Do not use abrasive

sponges. Do not put

water drawer inside a

dish washer.

After you clean the water drawer parts,

reassemble the water drawer.

1. Snap in the wave-breaker. Push it into

the drawer body.

2. Assemble the lid. First insert the front

snap and then push it against the

drawer body.

XAM

XAM

3. Insert the water drawer inside the

appliance.

4. Push the water drawer towards the

oven until it latches.

12.7 Steam generation system -

Descaling

When the steam generator operates,

limestone accumulates inside it (because

of calcium contents in the water). This can

have a negative effect on the steam

quality, on the performance of the steam

generator and on the food quality. To

prevent limestone accumulation, clean the

steam generation circuit.

Remove all accessories.

Select the function from the menu:

Cleaning. The user interface will guide you

through the procedure.

The duration of the complete procedure is

about 2 hours.

ENGLISH

55

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Comments to this Manuals

No comments