InstantaneousWater HeaterIH 18 electronic LCDIH 21 electronic LCDIH 24 electronic LCDInstructions for installation and use
10Water connectionThe water inlet temperature on the cold water connection should bemax. 70°C. Upwards of 45°C, the appliance system is arranged not t
11Installation versionsFor fittings directly on the appliance, the bushing openings pre-embossed inthe appliance hood must be cut out for the extensio
12Cleaning the strainer insertIf the water flowrate is reduced by dirt from the cold water line, the strainer-insert should be cleaned as follows:Flow
13Electrical connectionThe electrical connection should only ever be made after the water isconnected! The appliance is only suitable for a fixed conn
14Mains connection underneath (alternative)For this connectionversion, transpose themains connection terminal(1) from top to bottom.Note the terminald
15Temperature selector range limitationThe maximum temperature able to be set can be limited to 40°C or 45°C.Important! Before dismantling, set the kn
16Using the appliance for the first time and checkingThe unit must be installed and started up by an approved firm of installerswhich accepts liabilit
17Check the voltageClean strainer insert (seepage 12)Dismantle and clean thebubblers and showersheadsInspection and repair onlyby the trained engineer
18Fault indications- L1 or L3 phase missing- L2 phase missingFaultpatternIdicator Possible faultsLED 1 LED 21 No displayAppliance does not work- Flowr
19Important for the expertThe electronic controls the safety-function of the appliance. When a fault isnoticed, the fault indicator (LED) blinks and t
2Contents PageImportant instructions for the user 3General 3Operating the appliance 3Temperature preselection 3Hot water flowrate 4Care and maintenanc
Customer serviceIf your appliance has a fault, please contact your customer service centre foradvice.Electric appliances should only ever be repaired
3When the appliance is operated with a thermostatic mixer tap, thetemperature setting on the instantaneous water heater must be around 8°Chigher than
Hot water flowrateUp to the appliance’s max. power limit, the instantaneous water heatersupplies the set hot water temperature regardless of the water
Important instructions for the installerGeneralThe instantaneous water heater is manufactured and tested in conformity withthe valid IEC specification
6Technical data*) In addition to the flow pressures of the instantaneous water heater itself, consideration must be given to the pressure losses in
7Appliance functionThe fully electronically controlled ELECTROLUX IH instant water heater is apressurised appliance for the supply of one or more tapp
8Installing the applianceThe appliance should only ever be installed or stored in frost-freepremises.Dimensioned diagram1 = Quick fastener for applia
9Appliance installationCarefully unpack and take out the enclosed pack.Prepare the appliance for assembly.Hood dismountingPress in the engagement lug
Comments to this Manuals