Electrolux PU3650 Owner's Guide download pdf (Page 6)

WARNING:

Improper connection of the equipment-grounding (earthing) conductor can

result in a risk of electric shock. Check with a qualiﬁed electrician or service

person if you are in doubt as to whether the outlet is properly grounded

(earthed). Do not modify the plug provided with the appliance. If it will not ﬁt

the outlet, have the proper outlet installed by a qualiﬁed electrician. This

appliance is for use on a nominal 120 volt (see rating plate for correct

voltage) circuit and has a ground (earth) plug that looks like the plug

illustrated in Figure 2. Make sure that the appliance is connected to an

outlet having the same conﬁguration as the plug. No adapter should be

used with this appliance.

• If the power cable is damaged, use only an OEM replacement cable.

• Check the power unit on/off button and all inlet valves for operation.

• This power unit is intended for household and commercial use only.

Electrolux Owner’s Manual English

Installation Of Power Unit

The power unit hangs on the mounting bracket

which is screwed to the wall. The bottom screws

of the mounting bracket should be about 48”

(122 cm) up from the ﬂoor to allow convenient

removal of the dirt receptacle. For proper motor

cooling, there must be at least 12” (31 cm)

between unit and the ceiling (see Figure 1). If

mounting on plaster or panel walls, be sure

mounting screws enter studs. If mounting on

concrete wall, drill the wall with a masonry bit

and insert the appropriate wall anchors. Strip

the low-voltage wires that were installed with

the main trunk line. Connect the wires to the

spring loaded connectors on the back side of

the power unit. Connect the main tube line to

the left side of the power unit with the connector

and clamp provided. Do not cement this

connection to the power unit in case you wish

to remove at some future date. NOTE: For

paper bag units, follow directions provided with

unit. This unit may be vented outside to exhaust

fumes and germs. For optimum noise reduction,

this unit must be vented outside. Use the same

tubing and ﬁttings as before. Do not vent power

unit exhaust into a wall, ceiling or concealed

space of a building. Use two exhaust lines for

twin motor units. NOTE: On/off button on

power unit is only used for the inlet on power

unit. All other inlets operate automatically when

hose end is inserted into inlet valve. The power

cable has a three-prong female connector on

one end. This connector must be plugged into

the mating connector on the power unit. Plug

the other end of the power cable into the wall

electrical outlet. WIRING: Check local codes,

but use not less than #12-2 wire with ground.

Plug power unit cord into appropriate electrical

outlet. Be sure line voltage is sufﬁcient to

handle 20 amp load.

Grounding (Earthing)

Instructions

This appliance must be grounded (earthed). If it

should malfunction or break down, grounding

(earthing) provides a path of least resistance or

electric current to reduce the risk of electric shock.

This appliance is equipped with a cord having

an equipment-grounding (earthing) plug. The

plug must be plugged into an appropriate outlet

that is properly installed and grounded (earthed)

in accordance with all local codes and ordinances.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Electrolux PU3650 Owner's Guide Page 6

Comments to this Manuals

Related products and manuals for Vacuum cleaners Electrolux PU3650