Electrolux T8 Owner's Guide Page 13
- Page / 20
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
13
ENGLISH
REMOVING THE CONTENTS OF THE DUST
CONTAINER.
Always operate the cleaner with the dust container
installed.
14 Remove the dust container by pressing in the
two gray buttons on the dust container lid.
15 Remove the contents of the dust container by
pressing the gray button on the bottom of the
container.
16 Close the dust container trapdoor lid until it clicks
shut.
17
Replace the dust container by placing it base first
into the cleaner. Press down until it clicks into
place.
18 Lock the dust container in place by pushing
down on the handle until it clicks into place.
DISMANTLING THE DUST CONTAINER.
To ensure there is no restriction of airflow and
dust container for blockages.
19 There are 2 clips on the top part of the dust
one on the back. Release these clips and lift the
top part of the dust container assembly from the
clear dust bin.
filtration assembly. Be sure to remove any
obstructions that may be stuck in or on the
assembly.
21 Re-assemble the dust container by placing the
central filtration assembly back into the dust
container bin and securing the front and rear
clips.
CLEANING AND REPLACING THE MOTOR
PROTECTION FILTER.
22 Remove the dust container as previously
described.
23 Refer to the image for where to find the motor
protection filter. Lift the top plastic cover from
its position and pull the filter from its position.
To clean the filter rinse under cold water and
be sure to air dry for at least 24 hours before
placing it back in the vacuum cleaner.
FRANÇAIS
VIDER LE CONTENU DU CONTENANT À
POUSSIÈRE.
les deux boutons gris situés sur le couvercle du
en appuyant sur le bouton gris situé au bas du
contenant.
complètement.
DÉMONTAGE DU CONTENANT À POUSSIÈRE.
19 2 fermoirs sont présents sur la partie supérieure
déposant l’assemblage de filtration central dans le
et arrière.
NETTOYER ET REPLACER LE FILTRE DE
PROTECTION DU MOTEUR.
précédemment.
l’emplacement du filtre de protection du moteur.
froide et le faire sécher pendant 24 heures avant
de le replacer dans l’aspirateur.
ESPAÑOL
PARA VACIAR EL CONTENIDO DEL
CONTENEDOR DE POLVO
Siempre opere la aspiradora con el contenedor de
polvo instalado.
14 Quite el contenedor de polvo oprimiendo los
dos botones de color gris ubicados en la tapa
del contenedor de polvo.
15 Vacíe el contenido del contenedor de polvo
parte inferior del contenedor.
16 Cierre la tapa de contenedor de polvo hasta
escuchar un clic.
17 Instale el contenedor de polvo colocando
18 Asegure en contendor de polvo en su lugar
trabe en su lugar.
PARA DESMONTAR EL CONTENEDOR DE
POLVO.
inspeccionar el contenedor de polvo en busca de
19 Hay 2 broches en la parte superior del
situada al frente y otro en el dorso. Libere estos
trasnparente para polvo.
21 Vuelva a armar el contenedor de polvo
abrochando los broches ubicados al frente y
PARA LIMPIAR Y CAMBIAR EL FILTRO
PROTECTOR DEL MOTOR.
22 Quite el contenedor de polvo tal como se ha
descrito anteriormente.
ubica el filtro protector del motor. Levante la
al menos 24 horas antes de volverlo a instalar
en la aspiradora.
Related products and manuals for Vacuum cleaners Electrolux T8
(2 pages)
Vacuum cleaners Electrolux EL8602A Manual
(16 pages)
(16 pages)
© 2020, manymanuals.com. All rights reserved. | 0.126 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals