Electrolux EWF12732 User Manual download pdf (Page 17)

ENGLISH 17

To pause press Start/ Pause.

The indicator will start flashing.

-

Press the Start/Pause again.

The program will continue.

-

Changing a running program is possible

only by switching off the appliance.

Press the ‘On/Off’ button to cancel

the program and to turn off the

appliance.

-

5.2 Interruption Of A Program

5.3 Changing A Program

It is possible to change only some option

after the program has started.

Press the touchpad Start/Pause. The

indicator will start flashing.

1.

Change the options.2.

Press Start/Pause again. The program

will continue.

3.

While a program or the Delay Start is

operating, the appliance door is locked

and the display shows the indicator ‘ ’.

Press the ‘On/Off’ button again to start

the appliance. Now, you can set a new

washing program.

The appliance will not drain the

water.

-

5.4 Changing The Options

5.5 Opening The Door

First set the machine to PAUSE by pressing

the “Start/Pause” touchpad. Wait until the

door lock indicator ‘ ’ goes off, then the

door can be opened.

If the door lock indicator ‘ ’ does not

disappear, this means that the machine is

already heating and the water level is above

the bottom edge of the door or the drum is

turning. In this case the door CAN NOT be

opened.

If you can not open the door but you

need to open it you have to switch

the machine off by pressing the

‘On/Off’ button to deactivate the

appliance. After about 5 minutes the

door can be opened.

Pay attention to the water

level and water temperature.

CAUTION!

The appliance stops automatically.

The acoustic signal will operate.

The display will show ‘ ’.

The indicator of the touchpad

Start/Pause goes off.

-

-

-

-

-

-

-

-

The door lock indicator ‘ ’

goes off.

Remove the laundry from the

appliance. Make sure that the

drum is empty.

Keep the door ajar, to prevent the

mildew and odours.

Turn off the water tap.

5.6 At The End Of The Program

At the end of the program the

time remaining can suddenly

decrease from 7 minutes or less

to 0 due to the overestimated

total program time during the

load sensing phase. In some

cases (with perfectly balanced

load) the program time can be

shorter than the time estimated

after the load sensing phase is

completed. This is a normal

behavior of the machine and not

a cause for concern as it does

not compromise its performance.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 99 100

Comments to this Manuals

No comments