Electrolux EWF1286GDW User Manual download pdf (Page 14)

9.8 Cancelling a programme

1.

Press the button for some sec-

onds to cancel the programme and to

deactivate the appliance.

2.

Press the same button again to acti-

vate the appliance. Now, you can set

a new washing programme.

The appliance does not drain the

water.

9.9 Opening the door

While a programme or the delay start op-

erates, the appliance door is locked and

the display shows the indicator

.

CAUTION!

If the temperature and level of the

water in the drum are too high,

you cannot open the door.

Open the appliance door when the

delay start operates:

1.

Press to pause the appliance.

2.

Wait until the door lock indicator

goes off.

3.

Open the door.

4.

Close the door and press again.

The delay start continues to operate.

Open the appliance door when the

programme operates:

1.

Press the button for some sec-

onds to deactivate the appliance.

2.

Wait for some minutes and then open

carefully the appliance door.

3.

Close the appliance door.

4.

Set the programme again.

9.10 At the end of the

programme

• The appliance stops automatically.

• The acoustic signal operates (if it is acti-

vated).

•

In the display a

comes on.

•The indicator

goes off.

•

The door lock indicator goes off.

• Remove the laundry from the appliance.

Make sure that the drum is empty.

• Keep the door ajar, to prevent the mil-

dew and odours.

• Close the water tap.

•

Press the button

for some seconds

to deactivate the appliance.

The washing programme is

completed, but there is water in the

drum:

– The drum turns regularly to prevent the

creases in the laundry.

–

The door lock indicator

is on. The

door stays locked.

– You must drain the water to open the

door.

To drain the water:

1.

If necessary, decrease the spin

speed. If you set

, the appli-

ance only drains.

2.

Press . The appliance drains the

water and spins.

3.

When the programme is completed

and the door lock indicator

goes off, you can open the door.

4.

Press the button for some sec-

onds to deactivate the appliance.

The appliance drains and spins

automatically after approximately

18 hours (except for Wool pro-

gramme).

9.11 AUTO Stand-by option

The AUTO Stand-by option automatically

deactivates the appliance to decrease the

energy consumption when:

• You do not use the appliance for 5 mi-

nutes before you press

.

Press the button

to activate the ap-

pliance again.

• After 5 minutes from the end of the

washing programme

Press the button

to activate the ap-

pliance again.

The display shows the end of the last

set programme.

Turn the programme knob to set a new

cycle.

14

www.electrolux.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments