Electrolux Washing machines with EWM 1000 PLUS User Manual

Browse online or download User Manual for Washing machines Electrolux Washing machines with EWM 1000 PLUS. Service Bulletin.T65 [en]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Service-Bulletin
DGS-TDS-N © Electrolux
01.07.05
599 522 112Washing machines EN
Toploader
Program abort fault display EA0 / fault memory EA6 with program start
Cause: After program start a check is performed during the first 30 seconds whether the drum lid is
closed correctly or not.
Due to too big distances from the magnet (DSP) to the reed switch there is no influence of the
metal strip in the belt pulley. No impulses are passed on to the electronic. The electronic does
not detect a drum rotation and stops the program indicating fault EA0 and fault memory EA6.
Measure: 1.) In case of a service you have to install a new DSP no. 146822100/5 as first measure.
Furthermore, you have to check all plugs at the main electronic. Afterwards you must
perform a function test of the LED drum positioning by turning the drum manually to
position. With appliances without LED drum positioning you have to check the pass-
through directly at the plugs of the DSP. If the function test was not successful,
continue as described under point 2.
2.) 3 spacer washers, no. 899859118910/2 are laid under between tub and DSP. This has
a stronger effect on the metal segment by the magnet (DSP).
Disassemble belt pulley and DSP.
Assemble DSP at the top with one washer, at the bottom with two washers.
One washer Two washers
Possibly you have to abrade 6 injection points. These may grind at the DSP during the drum
rotation.
Injection
points
Page view 0
1 2

Summary of Contents

Page 1 - Service-Bulletin

Service-BulletinDGS-TDS-N © Electrolux01.07.05599 522 112Washing machines ENToploaderProgram abort fault display EA0 / fault memory EA6 with program s

Page 2

Remove both studs with the DSP, so that these do not brush against the belt pulley.Before AfterFrom factory the fault code EA6 is no longer included

Comments to this Manuals

No comments