Electrolux ZB284 User Manual download pdf (Page 8)

g

8

g

Dear Customer,

Please read these operating instruc-

tions carefully. Above all please

observe the safety information on the

first pages of these operating instruc-

tions! Please keep these operating

instructions for later reference. Pass

them on to any subsequent owner of

the appliance.

Description of the appliance

1 Dust container

2 Liquid collector

3 Dust filter

4 Release button

5 Charge control display

6 On/off switch

7 Charge socket

8 Wall mounting and charger

9 Jack plug

10 Mains plug

11 Wet vacuuming nozzle

12 Fold-down crevice nozzle

1 Safety instructions

• Do not vacuum wet surfaces.

• Do not use the vacuum cleaner on sur-

faces that have been treated with

flammable solvents until they are com-

pletely dry.

• Do not use your vacuum cleaner to

vacuum hot items such as a glowing

cigarette end.

• Never use the vacuum cleaner to pick

up combustible dust.

• Under no circumstances should you oil

or grease the motor.

• Do not expose the vacuum cleaner to

direct sunlight or any source of heat.

• For maintenance and repair please

contact your local dealer or authorised

service personnel. Never attempt to

repair your vacuum cleaner yourself.

• Only use the appropriate original

charging devices for this model.

;

This appliance complies with the fol-

lowing EC directives:

– 73/23/EWG dated 19.02.1973 “Low

Voltage Directive“, including Direc-

tive Amendment 93/68/EWG

– 89/336/EWG dated 03.05.1989 “EMC

Directive“, including Amendment

Directive 92/31/EWG

Before using for the first time

Before you use your vacuum cleaner

for the first time you should charge

the battery for approx. 14-16 hours.

With a fully charged battery you can

vacuum with model ZB 260 for approx.

9 minutes and with model ZB 264 for

approx. 10 minutes.

Attaching the wall mounting

(Fig. A)

To attach the wall mounting select a

position near a room socket and

remote from any source of dampness.

0 Hold the mounting against the wall

and mark the points for the fastening

screws.

0 Use a drill to drill the holes for the

screws, push in the plastic plugs pro-

vided and insert the screws so that

they project by just 7 mm.

0 Position the wall mounting, lower it

over the two screws and then tighten

the screws securely.

3

The appliance can equally well be

stored standing on a table, the floor or

any other horizontal surface.

3

The wet vacuuming nozzle can be

stored in the wall mounting (Fig. B).

ZB260.book Seite 8 Donnerstag, 10. August 2000 10:41 10

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Comments to this Manuals

No comments