Electrolux FQ73NSEV User Manual download pdf (Page 24)

sure the glass slides out of the

supports completely.

11. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the glass panel and the oven door. Do

the above steps in the opposite

sequence.

The screen-printing zone must face the

inner side of the door. Make sure that

after the installation the surface of the

glass panel frame on the screen-printing

zones is not rough when you touch it.

Make sure that you install the internal

glass panel in the seats correctly.

A

10.7 Replacing the lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

1. Turn off the oven.

Wait until the oven is cooled down.

2. Disconnect the oven from the mains.

3. Put a cloth on the bottom of the

cavity.

CAUTION!

Always hold the halogen

lamp with a cloth to prevent

grease residue from burning

on the lamp.

The back lamp

1. Turn the lamp glass cover to remove

it.

2. Clean the glass cover.

3. Replace the lamp with a suitable 300

°C heat-resistant lamp.

4. Install the glass cover.

11. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

11.1 What to do if...

Problem Possible cause Remedy

The oven does not heat

up.

The oven is deactivated. Activate the oven.

The oven does not heat

up.

The clock is not set. Set the clock.

The oven does not heat

up.

The necessary settings are

not set.

Make sure that the settings

are correct.

www.electrolux.com24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments