Electrolux ESF 235 User Manual download pdf (Page 12)

Installation

Positioning

In its standard version the machine is intended for instal-

lation on a kitchen sink or worktop. To function properly

the machine must be fully level. Its height can be adjusted

with the adjustable feet (8 mm each).

Water supply

The temperature of the water supply should not exceed

65°C and the pressure should be between 50-1000 kPa

(0.5-10 bar). It is important to have a tap or stopcock,

positioned close to the machine and with easy access.

Special mixer taps with dishwasher connections are

available, as well as adaptors for older mixer taps.

Connect the inlet hose to a tap with a 3/4" pipe thread. If

necessary, use the restrictor (1/2") supplied.

The inlet hose must not be joined onto any form of extension

hose. If it is too short, the entire hose must be replaced

with a longer high-pressure hose, specially designed for

the purpose. The machine end of this hose can be turned

in any direction. Loosen the retaining nut, turn the hose,

then retighten the nut.

Check that the nut and all other connections

are tight before the machine is moved into

position.

Use only the inlet hose supplied to the dishwas-

her, do not reuse the old inlet hose.

Discharge connection

Place the discharge hose over the sink as illustrated.

It must not at any point be higher up than 75 cm over the

surface which the dishwasher is standing on. If it runs higher,

operation of the dishwasher might be impaired. It is also

important to ensure that the inside diameter of the hose is

not less than 13 mm at any point. If the discharge hose is

too long it can easily be cut to the right length.

1. Cut the hose to a suitable length, using a sharp

knife.

2. Fit the elbow supplied onto the end of the hose.

Electrical connection

The dishwasher must be connected to an earthed wall

socket which must be easily accessible and protected by

a 10 Amp fuse.

Permanent electrical installation must be carried

out by an authorised electrician.

Before any work is carried out on the machine

it must be isolated from the electric mains supply,

for example by removing the plug from the

wall socket.

- 23 -

1 2 ... 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Electrolux ESF 235 User Manual Page 12

Comments to this Manuals

Related products and manuals for Dishwashers Electrolux ESF 235