Electrolux ESF 2410 User Manual download pdf (Page 5)

- 5 -

Rinse conditioner dispenser 1

Use of a rinse conditioner will result in cleaner and faster

drying of the load, since it helps water to run off. Too much

conditioner may result in streakiness, too little may cause

white spots. The dispenser holds about 140 ml. This is

enough for 40-70 wash cycles, depending on the dosage

setting. When the rinse conditioner level is approaching

the bottom of the scale it is time to refill the dispenser.

djust the dosage setting according to the hard-

ness in the water. Begin with the lowest dosage

setting and increase if necessary by turning the

arrow clockwise.

1. Swivel out the filler trough.

2. Fill up with rinse conditioner until the level reaches

up to the red mark on the level indicator tube; do

not overfill.

3. Wipe off any spillage carefully to prevent excessive

foaming during the next wash programme.

4. Close the filler trough afterwards.

Do not fill the rinse aid dispenser with liquid

detergent.

Spray arm 2

It is important to keep all the holes in the spray arm clear.

A clogged hole can seriously affect washing efficiency. If

the spray arm needs cleaning, unscrew the nut clockwise,

remove the washer and lift off the spray arm. Clear the

holes and shake out any food remnants.

Coarse filter 3

The purpose of the coarse filter is to catch large objects

such as toothpicks and pieces of eggshell. Make sure that

the filter is always clean. Lift it out and rinse it under running

water whenever necessary.

Fine filter 4

It is just as important to keep this filter clean. A dirty or

clogged filter will always impair washing efficiency. The

fine filter can easily be lifted out for cleaning when you

have removed the coarse filter.

Detergent dispenser 5

Consult the instructions on the detergent packet and fill

the compartment

Remember that the instructions usually

refer to full-size dishwashers, for example when using

detergent tablets, it is sufficient to use just half a tablet.

Only use detergents specially designed for

dishwashers.

Salt container 6

This dishwasher is equipped with a water softener for hard

water, therefore shall the rinse aid dispenser be set for a

low dosage. The lime in hard water causes white deposits

to occur on dishes and to the interior of the dishwasher.

To prevent this, the water has to pass through a special

container where the hardness is removed.

Since the water softener uses coarse dishwasher salt,

you will have to refill the salt container after a certain

umber of dishwashing cycles.

It is extremely important, that the salt container

is filled up with the coarse dishwasher salt

before using the dishwasher for the first time,

if you live in an area where the water is calci

ferous.

The indicator light on the control panel is lit when the

container requires refilling.

1. Unscrew the filler cap to the salt container anti-

clockwise.

2. Fill the salt container with water (only the first

time).

3. Fill the container with coarse salt, using the

funnel supplied.

4. Remove the funnel and wipe off any spillage

around the filler opening.

5. Screw the filler cap back properly in place.

The water softener is now ready for the first load of dishes.

Always make sure that there is coarse grained salt in the

container, which holds about 1 litre.

Use only special salt for dishwashing machines,

ordinary domestic salt can damage the water

softener.

How to adjust the water softener, see chapter ”Adjusting

the water softener”.

1 2 3 4 5 6 ... 16

Comments to this Manuals

No comments

Electrolux ESF 2410 User Manual Page 5

Comments to this Manuals

Related products and manuals for Dishwashers Electrolux ESF 2410