Electrolux ESF5206LOW User Manual

ESF5206LOWEN Dishwasher User Manual

2. To enter the user mode, press andhold Delay. At the same time turn theknob counterclockwise until theprogramme marker indicates the firstprogramme.

hardness of the water supply. Ifnot, adjust the level of the watersoftener.2. Fill the salt container.3. Fill the rinse aid dispenser.4. Open the wate

1. Press the release button (D) to openthe lid (C).2. Pour the rinse aid in the dispenser(A) until the liquid reaches the filllevel 'max'.3.

2. Press Delay to delay the start of theprogramme of 3 hours.The delay indicator comes on.3. Press Start.Start indicator comes on.When the countdown i

• In areas with hard and very hardwater we recommend to use plaindishwasher detergent (powder, gel,tablets containing no additionalagents), rinse aid

10. CARE AND CLEANINGWARNING!Before maintenance,deactivate the appliance anddisconnect the mains plugfrom the main socket.Dirty filters and cloggedspr

CAUTION!An incorrect position of thefilters can cause badwashing results and damageto the appliance.10.2 Cleaning the spray armsDo not remove the spra

Problem and alarm code Possible cause and solutionThe programme does not start. • Make sure that the appliance door is closed.• Press Start.• If the d

Problem and alarm code Possible cause and solutionThe appliance trips the circuit-beak‐er.• The amperage is insufficient to supply si‐multaneously all

Problem Possible cause and solutionThe dishes are wet. • For the best drying performance activate AirDry.• The programme does not have a drying phase

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

Refer to "Before first use", "Daily use" or "Hints andtips" for other possiblecauses.12. PRODUCT INFORMATION SHEETTrade

Water supplyCold water or hot water 2)max 60 °C1) Refer to the rating plate for other values.2) If the hot water comes from alternative source of ener

www.electrolux.com22

ENGLISH 23

www.electrolux.com/shop156932250-A-442018

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible f

• The operating water pressure (minimum andmaximum) must be between 0.5 (0.05) / 8 (0.8) bar(MPa)• Obey the maximum number of 13 place settings.• If t

• Connect the mains plug to the mainssocket only at the end of theinstallation. Make sure that there isaccess to the mains plug after theinstallation.

3. PRODUCT DESCRIPTION54810 9 116712 2311Worktop2Upper spray arm3Lower spray arm4Filters5Rating plate6Salt container7Air vent8Rinse aid dispenser9Dete

4. CONTROL PANEL1 2 34561On/off indicator2Programme marker3Indicators4Delay button5Start button6Programme knob4.1 IndicatorsIndicator DescriptionWashi

Programme Degree of soilType of loadProgrammephasesConsumption values1)Duration(min)Energy(kWh)Water(l) 2)Normal soilCrockery andcutlery• Prewash• Was

How to set the programmeselection modeThe appliance is in programme selectionmode when the on/off indicator is on andStart indicator flashes.After act