Electrolux ESF6510LOX User Manual download pdf (Page 63)

Problem Possible solution

Press Start.

If the delay start is set, cancel the setting or

wait for the end of the countdown.

The appliance does not fill with

water.

Make sure that the water tap is open.

Make sure that the pressure of the water sup-

ply is not too low. For this information, con-

tact your local water authority.

Make sure that the water tap is not clogged.

Make sure that the filter in the inlet hose is not

clogged.

Make sure that the inlet hose has no kinks or

bends.

The appliance does not drain the

water.

Make sure that the sink spigot is not clogged.

Make sure that the drain hose has no kinks or

bends.

The anti-flood device is on. Close the water tap and contact the Service.

After the checks are completed, activate

the appliance. The programme continues

from the point of interruption.

If the problem occurs again, contact the

Service.

If the display shows other alarm codes,

contact the Service.

10.1 If the washing and drying

results are not satisfactory

Whitish streaks or bluish layers on

glasses and dishes

• The released quantity of rinse aid is too

much. Adjust the rinse aid selector to a

lower position.

• The quantity of detergent is too much.

Stains and dry water drops on

glasses and dishes

• The released quantity of rinse aid is not

sufficient. Adjust the rinse aid selector

to a higher position.

• The quality of the detergent can be the

cause.

Dishes are wet

• The programme is without a drying

phase or with a low temperature drying

phase.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the

cause.

• The quality of the combi detergent tab-

lets can be the cause. Try a different

brand or activate the rinse aid dispens-

er and use rinse aid together with the

combi detergent tablets.

Refer to ‘HINTS AND TIPS’ for

other possible causes.

10.2 How to activate the rinse

aid dispenser

The activation of the rinse aid dispenser

can occur only with the Multitab option

activated.

1.

Press the on/off button to activate the

appliance.

2.

Press and hold, at the same time,

Program and Option for a few sec-

onds.

3.

Press and hold, at the same time, De-

lay and Start until the programme in-

dicators

, and

start to flash.

4. Press Option.

ENGLISH 63

1 2 ... 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments