Electrolux ENC2853AOW User Manual download pdf (Page 16)

Problem Possible cause Solution

Water flows on the floor. The melting water outlet

is not connected to the

evaporative tray above

the compressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be

set.

The "FastFreeze mode"

or "Shopping mode" is

switched on.

Switch off "FastFreeze

mode" or "Shopping mode"

manually, or wait until the

mode resets automatically to

set the temperature. Refer to

"FastFreeze mode" or

"Shopping mode".

DEMO appears on the dis‐

play.

The appliance is in dem‐

onstration mode.

Keep the Mode pressed for

approximately 10 seconds

until a long sound is heard

and display shuts off for a

short time.

The temperature in the ap‐

pliance is too low/too high.

The temperature regula‐

tor is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed

correctly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are

stored at the same time.

Add less food products at

the same time.

The door has been

opened often.

Open the door only if neces‐

sary.

The "FastFreeze mode"

or "Shopping mode" is

switched on.

Refer to "FastFreeze mode"

or "Shopping mode".

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance.

If the advice does not lead to

the desired result, contact

the nearest Authorised

Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer

to assembly instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

www.electrolux.com16

1 ... 15 16 17 18 19 20

Comments to this Manuals

No comments