Electrolux CARAVAN AES II RM 6505 Operations Instructions download pdf (Page 7)

• replace the upper door

• replace the control panel with its two screws.

INSTALLATION/BUILDING-IN

The refrigerator is intended for installation in a motor-

home, and the description relates to this application.

The refrigerator must not be exposed to radiated heat

from hot objects.

Excessive heat irradiation impairs performance and

leads to increased energy consumption. For this reason

the refrigerator should be installed if possible not at the

entrance side of the vehicle - normally orientated south

and often with an awning which would impair the disper-

sion of heat and combustion gases from the ventilation

openings.

It is not a good practice to install the refrigerator so that

the vent openings are covered by the vehicle’s entrance

door when this is set open. This would reduce the

ventilation airflow to the cooling unit and reduce refrigera-

tion performance.

The enclosure

The refrigerator must be installed in a substantial

enclosure and must be level, the dimensions are shown

in TECHNICAL DATA.

The bottom of the enclosure must be horizontal and even

so that the refrigerator can be easily pushed into place.

It must be sturdy enough to carry the weight of the

refrigerator.

Battens must be installed at the bottom, sides and top

of the enclosure and fitted with sealing strips.

Slide in the refrigerator until it is flush with the front of

the recess. There must be 10-20 mm free space behind

the refrigerator

Six fasteners are fitted in plastic bushings in the side

walls of the refrigerator, fig. 2. They are used for securing

the refrigerator in the enclosure.

The side walls of the enclosure and/or any wooden

braces installed to hold the refrigerator must be dimen-

sioned to seat the screws securely, also considering the

forces due to the movement of the vehicle.

With the refrigerator in place, drive the screws through

the lining of the refrigerator into the walls of the enclosure.

There must not be more than 3 mm of clearance be-

tween refrigerator and enclosure on each side. If neces-

sary, wooden strips or similar should be fitted.

Note: This is the only approved means of securing the

refrigerator to the enclosure and to the vehicle. Fasteners

penetrating other parts of the insulation (PU) foam of the

refrigerator might damage components like electric

wiring etc.

VENTILATION OF THE UNIT

At high ambient temperatures the refrigeration unit will

only perform adequately when properly ventilated.

Side ventilation.

The refrigerator unit is ventilated via two openings in the

wall of the motorhome (fig. 3a).

Fresh air enters through the lower opening and warm air

is discharged through the upper one.

The lower opening should be located at floor level (to

allow any leaking gas to escape to the outside).

The upper ventilation opening should be located above

the condenser, as high as possible, to ensure good

ventilation.

Roof ventilation

The ventilation of the cooling unit can also be done via

one opening in the wall of the motorhome and one on

the roof for the roof vent (fig. 3 b).

Fresh air enters through the lower opening and warm air

is discharged through the roof vent.

Ventilation grilles

We recommend fitting 2 side vents, model L500,

alternative one L500 and one roof vent model R500,

which are specially developed by Electrolux for this

purpose.

The L500-ventilation grilles permit inspection and small

repairs to be carried out without the necessity to remove

the refrigerator from the recess.

FIG. 2

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Electrolux CARAVAN AES II RM 6505 Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Fridges Electrolux CARAVAN AES II RM 6505