Electrolux EILFU17GS Service Manual download pdf (Page 46)

5-6

CCoommppoonneenntt TTeeaarrddoowwnn

Figure 5-11. Door Switch Removal

Figure 5-12. Upper Shelf Assembly Removal

DDoooorr SShheellff GGuuaarrdd RReemmoovvaall

The door shelf guard is secured to the inner door

panel with two tabs on each end.

To remove the door shelf guard, bend the door

shelf guard out in the middle and pull the tabs out

of the inner panel. (See Figure 5-10)

DDoooorr SSwwiittcchh RReemmoovvaall

The door switch is mounted inside a hole in the

cabinet base along the lower left hand side.

(See Figure 5-11)

To remove the door switch:

1. Remove kickplate.

2. Reach into the access hole next to the door

switch and disconnect the electrical leads from

the door switch terminals.

3. Press in on the retaining latch on the switch

body and push switch through hole in cabinet

base.

IInntteerriioorr CCoommppoonneennttss

UUppppeerr SShheellff AAsssseemmbbllyy

The upper glass shelf assemblies have metal bars

that slide into holes in the cabinet interior

sidewalls. The pizza shelf will fit on any of the

three upper glass shelves. (See Figure 5-12)

To remove the upper glass shelf assemblies:

1. If the pizza shelf is attached, remove first by

supporting the center of the shelf with one

hand and using the other hand to ease the

support tabs outward until the tabs drop

between the liner wall and the edge of the

shelf. Remove pizza shelf from unit.

2. Remove the glass shelves by pushing to the

right until the metal bars are free from the left

side liner wall. Then tilt down or up until the

shelf can be removed from the right side liner

wall.

Figure 5-10. Door Shelf Guard Removal

Door Shelf Guard

Door Switch

Locating

Holes in

Liner Wall

Access Hole

Bend Here

Glass Shelf

Pizza Shelf

Tabs

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 95 96

Comments to this Manuals

No comments

Electrolux EILFU17GS Service Manual Page 46

Comments to this Manuals

Related products and manuals for Fridges Electrolux EILFU17GS