Electrolux EN2401AOW User Manual download pdf (Page 60)

62 www.electrolux.com

• If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualied persons

in order to avoid a hazard.

• If the appliance is equipped with an Ice maker or a water

dispenser, ll them with potable water only.

• If the appliance requires a water connection, connect it to

potable water supply only.

• The inlet water pressure (minimum and maximum)must be

between 1 bar (0,1 MPa) and 10 bar (1 MPa)

2.1 Installation

WARNING!

Only a qualied person must install

this appliance.

• Remove all the packaging.

• Do not install or use a damaged

appliance.

• Obey the installation instruction

supplied with the appliance.

• Always be careful when you move the

appliance because it is heavy. Always

wear safety gloves.

• Make sure the air can circulate around

the appliance.

• Wait at least 4 hours before connecting

the appliance to the power supply. This

is to allow the oil to ow back in the

compressor.

• Do not install the appliance close to

radiators or cookers, oven or hobs.

• The rear of the appliance must stand

against the wall.

• Do not install the appliance where there

is direct sunlight.

• Do not install this appliance in areas

that are too humid or too colds, such

as the construction appendices,

garages or wine cellars.

• When you move the appliance, lift it by

the front edge to avoid scratching the

oor.

2.2 Electrical connection

WARNING!

Risk of re and electrical shock.

• The appliance must be earthed.

• All electrical connections should be

made by a qualied electrician.

• Make sure that the electrical information

on the rating plate agrees with the

power supply. If not, contact an

electrician.

• Always use a correctly installed

shockproof socket.

• Do not use multi-plug adapters and

extension cables.

• Make sure not to cause damage to the

electrical components (e.g. mains plug,

mains cable, compressor). Contact the

Service or an electrician to change the

electrical components.

• The mains cable must stay below the

level of the mains plug.

• Connect the mains plug to the

mains socket only at the end of the

installation. Make sure that there is

access to the mains plug after the

installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

2. SAFETY INSTRUCTIONS

02 12 2013_Electrolux -Rex UM_1.indb 62 2015-09-22 15:39:55

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 153 154

Comments to this Manuals

No comments

Electrolux EN2401AOW User Manual Page 60

Comments to this Manuals

Related products and manuals for Fridges Electrolux EN2401AOW