Electrolux ENB44693X User Manual download pdf (Page 28)

Problem Possible cause Solution

Water flows into the re-

frigerator.

The water outlet is clogged. Clean the water outlet.

Products prevent that water flows

into the water collector.

Make sure that products do not

touch the rear plate.

Water flows on the

ground.

The melting water outlet does not

flow in the evaporative tray above

the compressor.

Attach the melting water outlet to

the evaporative tray.

The temperature in the

appliance is too low.

The temperature regulator is not

set correctly.

Set a higher temperature.

The temperature in the

appliance is too high.

The temperature regulator is not

set correctly.

Set a lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

high.

Let the product temperature de-

crease to room temperature before

storage.

Many products are stored at the

same time.

Store less products at the same

time.

The temperature in the re-

frigerator is too high.

There is no cold air circulation in

the appliance.

Make sure that there is cold air cir-

culation in the appliance.

The temperature in the

freezer is too high.

Products are too near to each

other.

Store products so that there is cold

air circulation.

There is too much frost. Food is not wrapped correctly. Wrap the food correctly.

The door is not closed correctly. Refer to "Closing the door".

The temperature regulator is not

set correctly.

Set a higher temperature.

Replacing the lamp

1. Disconnect the plug from the mains

socket.

2. Press on the rear hook of the lamp cover

by a screwdriver and at the same time pull

and rotate the cover in the direction of the

arrow.

3. Replace the lamp with one of the same

power (the maximum power is shown on

the lamp cover).

4. Install the lamp cover by fixing it into its

original position.

5. Connect the plug to the mains socket.

6. Open the door. Make sure that the light

comes on.

max 25 W

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to "In-

stallation".

3. If necessary, replace the defective door

gaskets. Contact the Service Center.

28 electrolux

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Comments to this Manuals

No comments

Electrolux ENB44693X User Manual Page 28

Comments to this Manuals

Related products and manuals for Fridges Electrolux ENB44693X