Electrolux ER8137I User Manual download pdf (Page 7)

TECHNICAL SPECIFICATIONS

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate

correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For

operation with different voltages, a suitably sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

8mm

PR34

PR35

Position the runners (A) at the top and bottom

of the inside of the kitchen unit as shown in Fig.

and mark the position of the external holes.

After preparing the holes, screw the runners to

the kitchen unit door using 3.5x16 mm screws.

Open both the appliance door and that of the

kitchen unit to approx. 90°. Place the little plates

over the runners. Hold the doors of the appli-

ance and the unit together and mark the holes.

Remove the little plates and make the holes

with a diam. of 2 mm. Replace the little platee

over the runners and screw in the screws

provided (3.5x16 mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that

the doors of the appliance and the kitchen unit

open properly.

If the appliance is to be fitted laterally to the

kitchen unit, it will be sufficient to loosen the

screws of the little plates (D), move them as

shown in Fig. 11 and then fasten them up again.

Fit the cover (E).

Fig. 10

Fig. 11

Fig. 12

D734

PR33

20mm

Fig. 9

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Electrolux ER8137I User Manual Page 7