Electrolux ERB36301X8 User Manual download pdf (Page 49)

electrolux 49

GB

spacer (b) under the door mount is

also removed (Fig. 3).

Lift the freezer door up slightly and

remove.

Remove stops in both doors (t, z)

(Fig. 5).

Lift out the insert for the lower

covering grid (e) using a screw driver

(Fig. 4).

Unscrew the bottom door retaining pin

for the freezer door (h, f) and then

screw in on the other side. Don't

forget the spacer (h) (Fig. 4).

Insert the insert for the lower covering

grid (e) on the other side.

Fig.4

Remove the left-hand cover pin of the

double door mount (3 pieces, n, k)

and move to the other side (Fig. 3).

Disassemble the door locking

elements (u, v) by unscrewing the

screw (s) (Fig. 3).

Reverse the door locking elements (u,

v), move to the other side of the other

door and fix by screwing in the screw

(s).

Re-insert the stoppers (t, z) on the

other side of the doors.

Fig. 5.

Fit the pin of the double door mount

(m) into the left-hand hole of the

freezer door (Fig. 3).

Place the freezer door on the lower

door retaining pin (f) (Fig. 4).

Open doors and fix the double door

mount with 2 screws (c) on the left-

hand side. Don't forget the plastic

spacer under the door (b) as well. The

edges of the doors must run parallel to

the side edge of the appliance.

Place the fridge door on the double

door retaining pin.

Remove the top left-hand side door

mount (f) and the panel (c) from the

plastic bag and attach using the

screws (c) (Fig. 1).

Open the fridge door, attach the top

cover (j) using 2 screws (a); at the

same time pay attention to the

repositioning of the magnet (k), then

close the door (Fig. 2).

Put the appliance into position, make

adjustments if not horizontal and

connect to the electrical supply.

If you do not want to carry out these steps

yourself, please contact the nearest

branded service point. Technicians will

make a charge for door reversal.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

Comments to this Manuals

No comments