Electrolux ERE3600 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
77
Electrolux 818 34 37-05/5
Something Not Working
GB
Before contacting your local Service Force Centre check the following point:
Problem Possible cause / Remedy
"" is displayed in the temperature
display.
An error has occurred in measuring the temperature. Call your
service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
Audible alarm + flashing red warning
lamp. (It is too warm inside the freezer.)
Switch off the audible alarm by pressing the alarm off button.
The audible alarm could have been triggered by:
The cabinet having been recently switched on and the
temperature still being too high. See the chapter "Switching on
and setting the temperature".
The door may have been open for so long that the `door open'
alarm was triggered.
It is too warm inside the refrigerator. Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that t he
insulating strip is complete and clean.
It is too cold inside the refrigerator. Set a warmer temperature.
It is for cold in the "Natura-fresh" zone. Push the "-" and the "reset" buttons simultaneously about 5
seconds.
Water comes out on the floor. Place the drain hose at t he back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
It is too warm inside the freezer. Set a lower temperature.
Make sure that the door is completely closed and that t he
insulating strip is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
It is too cold inside the freezer. Set a warmer temperature.
Action Freeze could have been switched on.
The temperature display shows t he highest temperature inside
the cabinet. Thus a difference between the temperature
indicated on the display and the (average) temperature
measured in another way is normal.
Too much frost and ice are produced. Make sure that the door is completely closed and that t he
insulating strip is complete and clean.
The compressor operates continuously. Set a warmer temperature.
Make sure that the door is completely closed and that t he
insulating strip is complete and clean.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments