25
Fitting a unit door
1. Lift the fitting aids out to the
top, turn round and insert into
the adjacent openings.
Fasten the appliance in the recess
EURO IK 2760
• with the attachment profile
bm
at the top, fig. B1,
• with the hinges at the side, fig. B2,
• with the attachment element
bl
at the bottom, fig. B3.
SMS IK 319
• with the attachment profile
bm
at the top, fig. B1,
• with the hinges at the side, fig. B2,
• with the attachment element
9
at the bottom, fig. B4.
GB
2. Slide the fitting aids ➍ up level
with the unit door: underside of
stop edge of fitting aid = upper
edge of unit door.
3. Unscrew the counternuts ➌.
10. Attach bracket ➎ to housing
unit door with 4 x 14 wood
board screws ➐.
11. Loosen the cross-headed
screws ➏.
12. Align housing unit door parallel
to appliance door. Tighten M6
screws ➏.
13. Close the door and check dis-
tance between door and sur-
rounding housing unit doors.
4. Suspend the attachment strut ➊ on the unit door.
Depending on the width of the
recess, the middle line of the
attachment strut will have to be
moved towards the hinge!
5. Fasten the attachment strut ➊:
With at least 6 screws (4x14)
if the doors are made of wood
board. With 4 screws round
the edge in the case of panel
doors.
6. Lift the fitting aids ➍ out to the
top, turn round and insert into the adjacent openings.
7. Suspend the unit door on the
door of the appliance/adjusting
pins ➋. Screw the counternuts
➌ loosely onto the adjusting
pins.
8. Align the unit door flush with the
surrounding unit fronts: align
laaterally X by sliding in the
corresponding direction, adjust
height Y and lateral tilt with the
adjusting pins ➋ with a screw-
driver. Tighten counternuts ➌.
9. Adjust the depth of the unit door
Z: loosen the cross-headed screws ➑.
14. Cover the attachment brackets
with the cover strip
BO
and click
into place.
15. Click cover BSinto place.
Comments to this Manuals