Electrolux EGU6343LOX User Manual

EGU6343... ...EN GAS HOB USER MANUAL

WARNING!The following instructions about in-stallation, connection and mainte-nance must be carried out by quali-fied personnel in compliance withstan

It is important to install the elbowcorrectly, with the shoulder on theend of the thread, fitted to the hobconnecting pipe.Failure to ensure the corre

(screw type fuses removed from theholder), earth leakage trips and contac-tors.• The connection cable parts must not beheated to a temperature above 9

BAA)supplied sealB)supplied brackets7.8 Possibilities for insertionKitchen unit with doorThe panel installed below the hob must beeasy to remove and l

Gas supply: G20 (2H) 20 mbarAppliance class: 3By-pass diametersBurner Ø By-pass in1/100 mmAuxiliary 28Burner Ø By-pass in1/100 mmSemi-rapid 32Triple C

ENGLISH 15

www.electrolux.com/shop397274001-A-102012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. PRODUCT DES

1. SAFETY INFORMATIONThis appliance is suitable for the followingmarkets: GBBefore the installation and use of the appli-ance, carefully read the su

Gas connection• All gas connections should be made bya qualified person.• Make sure that there is air circulationaround the appliance.• The informatio

• Clean the appliance with a moist softcloth. Only use neutral detergents. Donot use abrasive products, abrasivecleaning pads, solvents or metal objec

thermocouple to warm up. If not, thegas supply will be interrupted.3.Adjust the flame after it is regular.If after some tries the burner doesnot light

4. HELPFUL HINTS AND TIPSWARNING!Refer to "Safety information" chap-ter.4.1 Energy savings• If possible, always put the lids on thepans.• Wh

Scratches or dark stains on thesurface have no effect on how theappliance operates.•You can remove the pan supports toeasily clean the hob.• To clean

Problem Possible cause RemedyThe gas ring burns un-evenly• Burner crown is blockedwith food residues• Make sure that the in-jector is not blockedand t