Electrolux EKM6045XN User Manual download pdf (Page 33)

CONNECTING TO GAS SUPPLY

This appliance is designed to be installed with an

appliance flexible connection only. Supply piping

should not be less than R

/8. Connection is made to

the Rc ½ (½” B.S.P.) female threaded entry pipe

located just below the hotplate level on the rear left

hand side of the appliance. NOTE: ONLY LIQUID

SEALANTS TO BE USED WHEN INLET GAS PIPE

IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT

TAPE. Carry out a gas tightness test after

connecting to the gas supply. The gas bayonet

connector must be fitted in the shaded area

indicated in Fg.3. Take into account that it must be

possible to pull the appliance forward sufficiently.

Ensure the hose does not become trapped when

pushing the appliance into position.

IMPORTANT: FLEXIBLE TUBING USED MUST

COMPLY WITH BS.669 CURRENT EDITION.

LPG Flexible connections must be a type suitable for

L.P.G and capable of operation up to 50 mbar and

carry a red stripe, band or label.

FITTING THE STABILITY CHAIN

It is recommended that if the appliance is to be

installed with a flexible supply pipe, a stability chain

be fitted and is available from your supplier (see

Important Safety Requirements). These instructions

should be read in conjunction with any leaflet packed

with the stability chain.

1. Place the appliance in its intended position and

level appliance.

2. Mark a position 100mm from the top of the rear

right hand corner.

3. Measure down 150mm from this point. This

gives the position of the wall anchor point for the

stability chain.

4. The stability chain anchor point on the appliance

is shown in the diagram Fig. 4.

PRESSURE TESTING

1. The Rapid injector is used as a pressure test

point.

2. Connect the pressure gauge to the Rapid

injector.

3. Check the supply pressure by turning the Rapid

burner on and one other hotplate burner full on

and light the appropriate burner. The pressure

should be either:-

(i) For Natural Gas 20mbar

(ii) For LP. Gas. The pressure must be set to

29 mbar for use on butane or 37 mbar for

use on propane.

4. Turn off the taps, disconnect the pressure

gauge.

5. Check operation of each hotplate burner.

Fig.3.

Fig.4.

1 ... 32 33 34 35 36

Comments to this Manuals

No comments

Electrolux EKM6045XN User Manual Page 33

Comments to this Manuals

Related products and manuals for Ovens Electrolux EKM6045XN