Electrolux 40 cm cordless Instruction Manual download pdf (Page 5)

5

CORRECT OPERATING POSITION

Trimming

Edging

(XT & TE)

WARNING:

Always wear eye pro-

tection. Never lean over the trimmer

head. Rocks or debris can ricochet or be

thrown into eyes and face and cause

blindness or other serious injury.

When operating unit, stand as shown and

check for the following:

S

Wear eye protection and heavy clothing.

S

Hold trigger handle with right hand and

assist handle with left hand.

S

Keep unit below waist level.

S

Cut from your right to your left to ensure

debris is thrown away from you. With -

out bending over, keep line near and

parallel to the ground (perpendicular

when edging) and not crowded into

material being cut.

ADJUSTING UPPER HANDLE

(XT Series only)

S

Press button located on the underside

of the upper handle and extend handle

to a comfortable position.

Button

ADVANCING THE CUTTING LINE

To advance the line, tap the bottom of the

cutting head on the groundwhile thetrim-

mer is running at full speed. The metal

blade attached to the shield will cut the

line to the proper length.

Cutting

Head

TAP

Metal Blade

TWIST ‘N EDGE

r

FEATURE

XT & TE series units are equipped with a

button on the side of the unit. If your unit

includes this feature you can press this

button and twist the lower portion 180

_

counterclockwise into an edging posi-

tion.

Twist ‘N Edge Button

MAINTENANCE

WARNING:

Disconnect power

source before performing maintenance.

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover

items that have been subjected to opera-

tor abuse or negligence. To receive full

value from the warranty, the operator

must maintain unit as instructed in this

manual. Various adjustments will need to

be made periodically to properly main-

tain your unit.

BEFORE EACH USE

CHECK FOR LOOSE FASTENERS

AND PARTS

S

Housing Screws

S

Assist Handle

S

Debris Shield

CHECK FOR DAMAGED OR

WORN PARTS

Contact an authorized service dealer for

replacement of damaged or worn parts.

S

Trigger Switch -- Ensure switch func-

tions properly by pressing and releas-

ing the trigger switch. Make sure motor

stops.

S

Debris Shield -- Discontinue use of unit

if debris shield is damaged.

AFTER EACH USE

INSPECT AND CLEAN UNIT AND LA-

BELS

S

After each use, inspect complete unit

for loose or damaged parts. Clean the

unit using a damp cloth with a mild de-

tergent.

S

Wipe off unit with a clean dry cloth.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments