Electrolux EAWE09E6CJW Troubleshooting Guide download pdf (Page 16)

Installation procedure

1. Remove the sticker from the front

panel.

2. Put the unit into the installation

hole.

3. When installing the unit, it should

be slanted down to the back to

avoid the enlargement of noise or

vibration (Slant between 6-10mm).

4. The installation place should be

strong enough to avoid the

enlargement of noise or vibration.

5. Fill up sews in the cabinet with

sponge or foam.

Installation assistance

1. Use iron support. The installation

hole should be strong enough to

support the air conditioner. If it

cannot, iron support has to be

used outdoors. Iron support should

be fixed on the building (Shown at

right figure).

2. Use sunshade board. Air

conditioner should avoid anything

to be dropped into it and avoid

direct sunshine. If there is no cover

on it, you should contact the seller

for installing the sunshade board.

When installing the sunshade

board, don’t let it block the air inlet

at the side grille.

Drain water

To get the maximum cooling

efficiency, the air conditioner is

designed to splash the condensation

water on the condenser coil.

If the splashing sound annoys you,

you can provide an outside drain by

using the following procedure, which

may however cause a small loss of

performance.

1. Slide out the chassis from the

cabinet.

2. Remove the rubber plug from the

body base plate.

3. Install the drain pan to the corner

of the cabinet with 2 screws.

4. Connect the drain hose to the

outlet on the drain pan bottom.

5. Slide the chassis into its original

place in the cabinet.

Sunshade board

Wooden

frame

Rubber

plate

6 ~10mm

Screws

Internal view

External view

Drain pan

Drain hose

Horizontal line

Support

6 ~10mm

Drain hose or tubing can be purchased locally to satisfy your particular needs.

29 electrolux installation

installation electrolux 30

ENG

ENG

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments