Electrolux EXP12HL1W Service Manual download pdf (Page 10)

(6) Timer button

Used to initiate the AUTO ON start time and AUTO OFF stop time program, in conjuction with the

(+)&(-) buttons. The timer on/off indicator light illuminates under the timer on/off settings.

(7) SWING button

(Applicable to the models with auto swing feature only)

Use to initiate the Auto swing feature when the operation is ON, press the SWING button can stop the

louver at the desired angle.

(8) LED Display

Show the set temperature in "℃" or "℉" and the Auto-timer settings. While on DRY and FAN modes, it

shows the room temperature.

Error codes:

E1- Room temperature sensor error-Unplug the unit and plug it back in. If error repeats, call for service.

E2- Evaporator temperature sensor error- Unplug the unit and plug it back in. If error repeats, call for

service.

E3- Condenser temperature sensor error- Unplug the unit and plug it back in. If error repeats, call for

service

E4- Display panel communication error- Unplug the unit and plug it back in. If error repeats, call for service.

P1- Bottom tray is full - Connect the drain hose and drain the collected water away. If error repeats,

call for service.

(9) FOLLOW ME/TEMP SENSING feature(optional)

NOTE: This feature can be activated from the remote control ONLY. The remote control serves as a

remote thermostat allowing for the precise temperature control at its location.

To activate the Follow Me/Temp Sensing feature, point the remote control towards the unit and press the

Follow Me/Temp Sensing button. The remote display is actual temperature at its location. The remote

control will send this signal to the air conditioner every 3 minutes interval until press the Follow

Me/Temp Sensing button again. If the unit does not receive the Follow Me /Temp Sensing signal during

any 7 minutes interval, the unit will beep to indicate the Follow Me/Temp Sensing mode has ended.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

No comments

Electrolux EXP12HL1W Service Manual Page 10