Electrolux EDI97170W User Manual download pdf (Page 24)

BUZZER permanent off 1. Turn the programme selector to any programme.

2. Press simultaneously the DRYNESS and DELICATE buttons

and hold down for approx. 5 seconds.

3. The buzzer is by default always off. You can use BUZZER button

to activate or deactivate sound but machine does not memorize

your selection.

Water hardness

Water contains, a variable

quantity of limestone and min-

eral salts of which quantities

vary according to geographical

locations thus varying its con-

ductivity values.

Relevant variations of the con-

ductivity of the water compared

to those prefixed by the factory

could slightly influence the re-

sidual humidity of the laundry at

the end of the cycle. Your dryer

allows you to regulate the sen-

sitivity of the drying sensor

based on conductivity values of

the water.

1. Turn the programme selector to any programme.

2. Press simultaneously the DELICATE and START/PAUSE but-

tons and hold down for approx. 5 seconds. The current setting

is on the display:

–

low conductivity <300 micro S/cm

–

medium conductivity 300-600 micro S/cm

–

high conductivity >600 micro S/cm

3. Press the START/PAUSE button sequentially until you set de-

sired level.

4. To memorize setting press simultaneously the the DELICATE

and START/PAUSE buttons or turn knob to O OFF position

Hints for test institutes

Parameters possible to checked by the Test

Institutes:

• Energy consumption (corrected with final

humidity) during the cupboard dry cotton

cycle with nominal load.

• Energy consumption (corrected with final

humidity) during the cupboard dry cotton

cycle with half load.

• Final humidity (during cupboard dry cot-

ton, iron dry cotton and cupboard dry easy

care)

• Condensation efficiency (corrected with fi-

nal humidity) during cupboard dry cotton

cycle with nominal and half load

All the cycles have to be checked in accord-

ance with EN 61121 (Tumble dryers for

household use – Methods for measuring the

performance).

Installation

Important! The appliance must be moved in

vertical position for transport.

Appliance positioning

• It is recommended that, for your conven-

ience, the machine is positioned close to

your washing machine.

• The tumble dryer must be installed in a

clean place, where dirt does not build up.

• Air must be able to circulate freely all round

the appliance. Do not obstruct the front

ventilation grille or the air intake grilles at

the back of the machine.

• To keep vibration and noise to a minimum

when the dryer is in use, it should be

placed on a firm, level surface.

• Once in its permanent operating position,

check that the dryer is absolutely level with

the aid of a spirit level. If it is not, raise or

lower the feet until it is.

• The feet must never be removed. Do not

restrict the floor clearance through deep-

pile carpets, strips of wood or similar. This

might cause heat built-up which would in-

terfere with the operation of the appliance.

Important!

The hot air emitted by the tumble dryer can

reach temperatures of up to 60°C. The ap-

pliance must therefore not be installed on

floors which are not resistant to high temper-

atures.

24 electrolux

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Comments to this Manuals

No comments

Electrolux EDI97170W User Manual Page 24

Comments to this Manuals

Related products and manuals for Tumble dryers Electrolux EDI97170W