Electrolux EDI97170W User Manual download pdf (Page 22)

Make an adjustment using the

DRYNESS function (see chap-

ter ”Drying”)

Conductance of water at installa-

tion site differs from standard set-

ting of machine.

Re-programme standard setting for

degree of drying (see ‘Program-

ming options’ chapter).

When a button is pressed

- no reaction of the ma-

chine.

Drying protection. After the start of

the programme, the option can no

longer be set.

Turn the programme knob to OFF.

Set the programme again.

Drum light does not work.

Programme selector in OFF posi-

tion.

Turn programme selector to any

programme.

Defective light bulb.

Replace light bulb (see next sec-

tion).

Displayed programme

time changes erratically or

stays unchanged for a

long time.

Programme time is corrected auto-

matically depending on type and

volume of laundry and level of

dampness.

Automatic process; this is not a

machine fault.

Programme inactive,

CONTAINER display illu-

minated.

Condensed water container is full.

Empty Condensed water contain-

er , then start programme with

START/PAUSE button.

Drying cycle ends shortly

after programme starts.

ANTICREASE display

illuminated.

Not enough washing loaded or

washing loaded is too dry for selec-

ted programme.

Select time programme or higher

drying level (e.g.

EXTRA instead

of

CUPBOARD).

Drying cycle lasts an un-

usually long time. Note:

After up to 5 hours the

drying cycle ends auto-

matically (see ‘End of dry-

ing cycle’).

Lint filter clogged. Clean lint filter.

Fluff filter clogged. Clean fluff filter.

Load volume too big. Reduce load volume.

Laundry insufficiently spun. Laundry must be adequately spun.

Particularly high room temperature.

Temporary switching off of the

compressor to avoid overload.

Automatic process, there is no fault

with the appliance. If possible, low-

er the room temperature.

Discoloration Colour fastness of textiles.

Check colour fastness of textiles.

Only treat textiles together if they

are a similar colour.

Changing the bulb for interior lighting

Only use a special bulb which is designed

specially for dryers. The special bulb can be

obtained from your local Service Force cen-

tre.

Warning! When the appliance is

switched on, the interior lighting

switches itself off after 4 minutes when

the door is open.

Warning! Do not use standard bulbs!

These develop too much heat and may

damage the machine!

Warning! Before replacing the bulb,

disconnect the mains plug.

1. Unscrew cover above the bulb (this can

be found directly behind the loading aper-

ture, at the top; refer to “Description of

machine” section.)

2. Replace defective bulb.

3. Screw cover back down.

22 electrolux

1 ... 21 22 23 ... 56

Comments to this Manuals

No comments